J617_202009 Engine Flywheel Housing and Mating Transmission Housing Flanges

Stabilized

09/29/2020

Features
Issuing Committee
Scope
Content
This SAE Standard specifies the major dimensions and tolerances for Engine Flywheel Housings and the Mating Transmission Housing Flanges. It also locates the crankshaft flange face or the transmission pilot bore (or pilot bearing bore) stop face in relation to housing SAE flange face.
This document is not intended to cover the design of the flywheel housing face mating with the engine crankcase rear face or the design of housing walls and ribs. Housing strength analysis and the selection of housing materials are also excluded.
This document applies to any internal combustion engine which can utilize SAE No. 6 through SAE No. 00 size flywheel housing for mounting a transmission.
Meta TagsDetails
DOI
https://doi.org/10.4271/J617_202009
Pages
9
Citation
SAE International Technical Standard, Engine Flywheel Housing and Mating Transmission Housing Flanges, SAE Standard J617_202009, Stabilized September 2020, Revised April 2014, Issued March 1916, https://doi.org/10.4271/J617_202009.
Additional Details
Publisher
Published
Sep 29, 2020
Product Code
J617_202009
Content Type
Technical Standard
Status
Stabilized
Language
English