J617_199205 ENGINE FLYWHEEL HOUSING AND MATING TRANSMISSION HOUSING FLANGES

Revised

05/01/1992

Features
Issuing Committee
Scope
Content
This SAE Standard specifies the major dimensions and tolerances for Engine Flywheel Housings and the Mating Transmission Housing Flanges. It also locates the crankshaft flange face or the transmission pilot bore (or pilot bearing bore) stop face in relation to housing SAE flange face.
This document is not intended to cover the design of the flywheel housing face mating with the engine crankcase rear face or the design of housing walls and ribs. Housing strength analysis and the selection of housing materials are also excluded.
This document applies to any internal combustion engine which can utilize SAE No. 6 through SAE No. 00 size flywheel housing for mounting a transmission.
Meta TagsDetails
DOI
https://doi.org/10.4271/J617_199205
Pages
11
Citation
SAE International Technical Standard, ENGINE FLYWHEEL HOUSING AND MATING TRANSMISSION HOUSING FLANGES, SAE Standard J617_199205, Revised May 1992, Issued March 1916, https://doi.org/10.4271/J617_199205.
Additional Details
Publisher
Published
May 1, 1992
Product Code
J617_199205
Content Type
Technical Standard
Status
Revised
Language
English