Search
Advanced Search
of the following are true
(
)

Results

Items (212,785)
This specification provides dimensional standards for crimp type contact wire barrel design and is a replacement for MS3190. Some wire barrel designs may exist in AS39029 but are not considered approved for future use, therefore, will not appear in this specification. The crimp barrel sizes listed in this document have been standardized in AS39029 and AS22520 specifications, tools and contacts are available to support these listed sizes. These crimp barrel requirements shall be used for any contact, regardless of whether it is a standard or non-standard contact configuration. The specification lists details for three types of wire barrels: A, B, and C. Wire barrel type A is not recommended for new design. Table 4 lists each AS39029 detail sheet wire barrel type.
AE-8C1 Connectors Committee
This material type has resistance to hot air, but generally has poor resistance to fuels and lubricants, but usage is not limited to such applications. Each application should be considered separately. This material type has a typical service temperature range of -85 to 500 °F (-65 to 260 °C). The operating temperature range of the material is a general temperature range, but the presence of particular fluids and design parameters may modify this range. Recommendations on the material selection are based on available technical data and are offered as suggestions only. Each user should make his own tests to determine the suitability for his own particular use.
A-6C2 Seals Committee
This document contains information and guidance necessary for the development of a representative, repeatable validation program that may be utilized to assess the capability of SHM systems. The nature of SHM data differs from that seen in traditional nondestructive evaluation (NDE) applications in that the position of SHM sensors is fixed and SHM data can be available much more frequently (if not continuously) over time. This document presents methodologies that can be used to arrive at SHM capability while considering the unique nature of SHM deployment. Each SHM system must be considered independently to determine the applicability and limitations of the guidance contained here for each SHM system being assessed.
Aerospace Industry Steering Committee on Structural Health
This SAE Recommended Practice establishes recommended procedures for the issuance, assignment, and structure of Identification Numbers on a uniform basis by states or provinces for use in an Assigned Identification Number (AIN).
VIN - WMI Technical Committee
This specification covers the procurement requirements for corrosion resistant steel retaining rings of the tapered width type with rectangular and beveled cross-sections.
E-25 General Standards for Aerospace and Propulsion Systems
This SAE Aerospace Information Report (AIR) contains a description of the design approach, the calculations, some comparisons to alternate SAE Aerospace Recommended Practice (ARP) documents, and the background information used to generate the standard face seal gland dimensions specified in AS6235. NOTE: This AIR should be read in conjunction with AS6235. In some instances, the information contained within AS6235 is repeated for clarity.
A-6C2 Seals Committee
This SAE Aerospace Information Report (AIR) provides descriptions of aircraft flight control actuation system failure-detection methods. The fault-detection methods are those used for ground and in-flight detection of failures in electrohydraulic actuation systems for primary flight controls.
A-6A3 Flight Control and Vehicle Management Systems Cmt
The test procedure and related limit value are intended to apply to new, previously untested designs of fixed ground pressure fuel dispensing systems.
AE-5C Aviation Ground Fueling Systems Committee
This specification covers a titanium alloy in the form of bars, wire, forgings, flash welded rings 4.000 inches (101.60 mm) and under in nominal diameter or least distance between parallel sides and stock of any size for forging or flash welded rings (see 8.8).
AMS G Titanium and Refractory Metals Committee
Items per page:
1 – 50 of 212785