This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Engine Flywheel Housing and Mating Transmission Housing Flanges
- Ground Vehicle Standard
- J617_201205
- Stabilized
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Standard specifies the major dimensions and tolerances for Engine Flywheel Housings and the Mating Transmission Housing Flanges. It also locates the crankshaft flange face or the transmission pilot bore (or pilot bearing bore) stop face in relation to housing SAE flange face. This document is not intended to cover the design of the flywheel housing face mating with the engine crankcase rear face of the design of housing walls and ribs. Housing strength analysis and the selection of housing materials are also excluded. This document applies to any internal combustion engine which can utilize SAE No. 6 through SAE No. 00 size flywheel housing for mounting a transmission.
Rationale
The technical report covers technology, products, or processes which are mature and not likely to change in the foreseeable future.
Recommended Content
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Automatic Transmission and Transaxle Committee
The Automatic Transmission and Transaxle Standards Committee reports to the Powertrain Systems Group of the Motor Vehicle Council. The Committee is responsible for developing and maintaining SAE Standards, Recommended Practices, and Information Reports related to all systems, subsystems, and components of automatic transmissions, including both step ration and CVT designs. This committee will direct its attention to passenger cars and light trucks. Participants in the SAE Automatic Transmission Transaxle Standards Committee include OEMs, suppliers, consulting firms, government, and other interested parties.
Reference
Number | Title |
---|---|
ANSI/B1.1 | This document is not part of the subscrption. |
ANSI/Y14.5 | This document is not part of the subscrption. |
ISO7648 | This document is not part of the subscrption. |
ISO7649 | This document is not part of the subscrption. |
J1033_201206 | Procedure for Measuring Bore and Face Runout of Flywheels, Flywheel Housings, and Flywheel Housing Adapters |
J1033_201206 | Procedure for Measuring Bore and Face Runout of Flywheels, Flywheel Housings, and Flywheel Housing Adapters |
J1172_201210 | Engine Flywheel Housings with Sealed Flanges |
J1172_201210 | Engine Flywheel Housings with Sealed Flanges |
J542C_197812 | Starting Motor Mountings |
J543C_197604 | Starting Motor Pinions and Ring Gears |
J615_200807 | Engine Mountings |
J616C_197806 | Engine Foot Mounting (Front and Rear) |
J621D_197703 | Industrial Power Take-Offs With Driving Ring-Type Overcenter Clutches |
J621_201210 | Industrial Power Take-Offs With Driving Ring-Type Overcenter Clutches |
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.