This content is not included in your SAE MOBILUS subscription, or you are not logged in.

The Effects of Injector Temperature on Spray Characteristics in Heavy-Duty Diesel Sprays

Journal Article
2018-01-0284
ISSN: 1946-3936, e-ISSN: 1946-3944
Published April 03, 2018 by SAE International in United States
The Effects of Injector Temperature on Spray Characteristics in Heavy-Duty Diesel Sprays
Sector:
Citation: Daly, S., Cenker, E., Pickett, L., and Skeen, S., "The Effects of Injector Temperature on Spray Characteristics in Heavy-Duty Diesel Sprays," SAE Int. J. Engines 11(6):879-891, 2018, https://doi.org/10.4271/2018-01-0284.
Language: English

References

  1. Pickett , L.M. , Manin , J. , Genzale , C. , Siebers , D. et al. Relationship between Diesel Fuel Spray Vapor Penetration/Dispersion and Local Fuel Mixture Fraction SAE Int. J. Engines 4 1 764 799 2011 10.4271/2011-01-0686
  2. Pickett , L.M. and Abraham , J. Computed and Measured Fuel Vapor Distribution in a Diesel Spray 20 3 241 250 2010 10.1615/AtomizSpr.v20.i3.50
  3. Som , S. , D'Errico , G. , Longman , D. , and Lucchini , T. Comparison and Standardization of Numerical Approaches for the Prediction of Non-Reacting and Reacting Diesel Sprays SAE Technical Paper 2012-01-1263 2012 10.4271/2012-01-1263
  4. Pickett , L.M. , Manin , J. , Payri , R. , Bardi , M. et al. Transient Rate of Injection Effects on Spray Development SAE Technical Paper 2013-24-0001 2013 10.4271/2013-24-0001
  5. Payri , R. et al. A New Methodology for Correcting the Signal Cumulative Phenomenon on Injection Rate Measurements Experimental Techniques 32 1 46 49 2008 10.1111/j.1747-1567.2007.00188.x
  6. Payri , R. et al. Using Spray Momentum Flux Measurements to Understand the Influence of Diesel Nozzle Geometry on Spray Characteristics Fuel 84 5 551 561 2005 10.1016/j.fuel.2004.10.009
  7. Knox , B.W. , Franze , M.J. , and Genzale , C.L. Diesel Spray Rate-of-Momentum Measurement Uncertainties and Diagnostic Considerations Journal of Engineering for Gas Turbines and Power 138 3 031507-031507-9 2015 10.1115/1.4031432
  8. Technical University of Valencia Virtual Injection Rate Generator http://www.cmt.upv.es/ECN03.aspx 2017
  9. Wang , T.C. et al. Parametric Characterization of High-Pressure Diesel Fuel Injection Systems Journal of Engineering for Gas Turbines and Power 125 2 412 426 2003 10.1115/1.1498268
  10. Lai , M.-C. , Wang , T. , Xie , X. , Han , J. et al. Microscopic Characterization of Diesel Sprays at VCO Nozzle Exit SAE Technical Paper 982542 1998 10.4271/982542
  11. Heimgärtner , C. and Leipertz , A. Investigation of the Primary Spray Breakup Close to the Nozzle of a Common—Rail High Pressure Diesel Injection System SAE Technical Paper 2000-01-1799 2000 10.4271/2000-01-1799
  12. Blessing , M. , König , G. , Krüger , C. , Michels , U. et al. Analysis of Flow and Cavitation Phenomena in Diesel Injection Nozzles and Its Effects on Spray and Mixture Formation SAE Technical Paper 2003-01-1358 2003 10.4271/2003-01-1358
  13. Payri , R. , Salvador , F. , Gimeno , J. , and de la Morena , J. Macroscopic Behavior of Diesel Sprays in the Near-Nozzle Field SAE Int. J. Engines 1 1 528 536 2008 10.4271/2008-01-0929
  14. Jung , Y. , Manin , J. , Skeen , S. , and Pickett , L. Measurement of Liquid and Vapor Penetration of Diesel Sprays with a Variation in Spreading Angle SAE Technical Paper 2015-01-0946 2015 10.4271/2015-01-0946
  15. Jung , Y. , Manin , J. , Skeen , S. , and Pickett , L. Assessment of the Ignition and Lift-Off Characteristics of a Diesel Spray with a Transient Spreading Angle SAE Technical Paper 2015-01-1828 2015 10.4271/2015-01-1828
  16. O'Connor , J.F. CFD Predictions of the Effect of Fuel Temperature on Heavy Duty Diesel Engine NOx and Soot Emissions SAE Technical Paper 1999-01-0842 1999 10.4271/1999-01-0842
  17. Salvador , F.J. et al. Fuel Temperature Influence on the Performance of a Last Generation Common-Rail Diesel Ballistic Injector. Part I: Experimental Mass Flow Rate Measurements and Discussion Energy Conversion and Management 114 364 375 2016 10.1016/j.enconman.2016.02.042
  18. Manin , J. et al. Boundary Condition and Fuel Composition Effects on Injection Processes of High-Pressure Sprays at the Microscopic Level International Journal of Multiphase Flow 83 267 278 2016 10.1016/j.ijmultiphaseflow.2015.12.001
  19. Payri , R. et al. A New Approach to Compute Temperature in a Liquid-Gas Mixture. Application to Study the Effect of Wall Nozzle Temperature on a Diesel Injector International Journal of Heat and Fluid Flow 68 79 86 2017 10.1016/j.ijheatfluidflow.2016.12.008
  20. Musculus , M.P.B. and Kattke , K. Entrainment Waves in Diesel Jets SAE Int. J. Engines 2 1 1170 1193 2009 10.4271/2009-01-1355
  21. Siebers , D.L. Liquid-Phase Fuel Penetration in Diesel Sprays SAE Technical Paper 980809 1998 10.4271/980809
  22. Westlye , F.R. , Battistoni , M. , Skeen , S. , and Manin , J. Penetration and Combustion Characterization of Cavitating and Non-Cavitating Fuel Injectors under Diesel Engine Conditions SAE Technical Paper 2016-01-0860 2016 10.4271/2016-01-0860
  23. Sandia National Laboratories Engine Combustion Network http://www.ecn.sandia.gov/ 2017
  24. Meijer , M. et al. Engine Combustion Network (ECN): Characterization and Comparison of Boundary Conditions for Different Combustion Vessels Atomization and Sprays 22 9 777 806 2012 10.1615/AtomizSpr.2012006083
  25. Naber , J.D. and Siebers , D.L. Effects of Gas Density and Vaporization on Penetration and Dispersion of Diesel Sprays SAE Technical Paper 960034 1996 10.4271/960034
  26. Payri , R. et al. Hydraulic Characterization of Diesel Engine Single-Hole Injectors Fuel 180 357 366 2016 10.1016/j.fuel.2016.03.083
  27. Kastengren , A.L. et al. Engine Combustion Network (ECN): Measurements of Nozzle Geometry and Hydraulic Behavior Atom. Sprays 22 12 1011 1052 2012
  28. Zhang , Q. and Johari , H. Effects of Acceleration on Turbulent Jets Physics of Fluids 8 8 2185 2195 1996

Cited By