Dimethyl Ether Biogas Reactivity-Controlled Compression Ignition for Sustainable Power Generation with Low Nitrogen Oxide Emissions
- Features
- Content
- Biogas (60% methane–40% CO2 approximately) can be used in the reactivity-controlled compression ignition (RCCI) mode along with a high-reactivity fuel (HRF). In this work dimethyl ether (DME) that can also be produced from renewable sources was used as the HRF as a move toward sustainable power generation. The two-cylinder turbocharged diesel engine modified to work in the DME–biogas RCCI (DMB-RCCI) mode was studied under different proportions of methane (45–95%) in biogas since the quality of this fuel can vary depending on the feedstock and production method. Only a narrow range of biogas to DME ratios could be tolerated in this mode at each output without misfire or knock. Detailed experiments were conducted at brake mean effective pressures (BMEPs) of 3 and 5 bar at a speed of 1500 rpm and comparisons were made with the diesel–biogas dual-fuel and diesel–biogas RCCI modes under similar methane flow rates while the proportion of CO2 was varied. The DMB-RCCI mode exhibited superior brake thermal efficiency (25.3% as against 22% and 31.5% as against 29% at the BMEPs of 3 and 5 bar) as compared to the other modes and was not sensitive to the concentration of methane. The NOx and soot emissions were also negligible and the lowest CH4 emission levels were also attained. The cyclic fluctuations in IMEP were lower than 5% in this mode. Thus, DME can be used along with biogas to enhance its reactivity for sustainable power generation in the RCCI mode.
- Pages
- 19
- Citation
- Gopa Kumar, S., Mohan, A., and Ramesh, A., "Dimethyl Ether Biogas Reactivity-Controlled Compression Ignition for Sustainable Power Generation with Low Nitrogen Oxide Emissions," SAE Int. J. Engines 17(7):925-943, 2024, https://doi.org/10.4271/03-17-07-0054.