J620_198810 FLYWHEELS FOR INDUSTRIAL ENGINES USED WITH INDUSTRIAL POWER TAKE-OFFS EQUIPPED WITH DRIVING-RING TYPE OVERCENTER CLUTCHES AND ENGINE MOUNTED MARINE GEARS AND SINGLE BEARING ENGINE MOUNTED POWER GENERATORS
Revised
10/01/1988
- Features
- Issuing Committee
- Content
- This SAE standard defines flywheel configuration for industry standardization, interchangeability, and compatibility.Table 1 and the figure give the dimensions for the flywheels.For dimensions of industrial power take-offs with driving-ring type over-center clutches, see SAE J621.For flywheel dimensions for engine mounted torque converters without front disconnect clutch, see SAE J927.
- Pages
- 6
- Citation
- SAE International Technical Standard, FLYWHEELS FOR INDUSTRIAL ENGINES USED WITH INDUSTRIAL POWER TAKE-OFFS EQUIPPED WITH DRIVING-RING TYPE OVERCENTER CLUTCHES AND ENGINE MOUNTED MARINE GEARS AND SINGLE BEARING ENGINE MOUNTED POWER GENERATORS, SAE Standard J620_198810, Revised October 1988, Issued January 1953, https://doi.org/10.4271/J620_198810.