J285_201904 Dispenser Nozzle Spouts for Liquid Fuels Intended for Use with Spark Ignition and Compression Ignition Engines

Revised

04/29/2019

Features
Issuing Committee
Scope
Content
This SAE Recommended Practice provides standard dimensions for liquid fuel dispenser nozzle spouts and a system for differentiating between nozzles that dispense liquid fuel into vehicles with spark ignition (SI) engines and compression ignition (CI) engines for land vehicles. Current legal definitions only distinguish between “Unleaded Fuel” and “All Other Types of Fuel.” These definitions are no longer valid. This document establishes a new set of definitions that have practical application to current automobile liquid fuel inlets and liquid fuel dispenser nozzle spouts.
Rationale
Content
With the introduction of Phase II Enhanced Vapor Recovery nozzles and automotive fuel system designs that utilize capless filler receptacles, improved definition of the interface for the fuel dispenser nozzle spout is required. This document is intended to give a general dimensional layout for conventional petrol, Enhanced Conventional (ECO) petrol, Phase II petrol, and Phase II Enhanced Vapor Recovery (EVR) petrol dispenser spouts, which are used to refuel a wide range of vehicles. Specifying general dimensional requirements will ensure compatibility between the nozzle and vehicle fill pipe interface.
Meta TagsDetails
DOI
https://doi.org/10.4271/J285_201904
Pages
21
Citation
SAE International Recommended Practice, Dispenser Nozzle Spouts for Liquid Fuels Intended for Use with Spark Ignition and Compression Ignition Engines, SAE Standard J285_201904, Revised April 2019, Stabilized May 2012, Reaffirmed January 1999, Issued June 1972, https://doi.org/10.4271/J285_201904.
Additional Details
Publisher
Published
Apr 29, 2019
Product Code
J285_201904
Content Type
Recommended Practice
Status
Revised
Language
English