J2846_201005 Laboratory Measurement of the Acoustical Performance of Body Cavity Filler Materials

Issued

05/26/2010

Features
Issuing Committee
Scope
Content
This SAE Recommended Practice describes a laboratory test procedure for measuring the acoustical performance of a system consisting of a body cavity filler material formed into a rectangular cross-section channel. Materials for this test may include both heat reactive and chemically reactive products, with or without a shelf to simulate a baffle in an application, or a combination of body cavity filler and aluminum foil to enhance the performance. These materials are commonly installed in transportation systems such as ground vehicles, and thus reduce the noise propagation through the rails, rockers, and pillar/posts.
This document is intended to rank order the acoustical performance of materials for application on channels using general automotive steel, such that the effects of sealing of pinch welds in addition to the material could be easily evaluated. However, the channel is not an actual part (i.e., real life section) of the vehicle, and therefore results obtained from this study will have to be carefully interpreted considering limitations of section size/shape and full sealing (or not) of the section.
The acoustical performance is expressed in terms of insertion loss (IL) which is described in Section 3 Test Method. The test procedure described here is based on the method described in SAE J1400. However, this document differs from the SAE J1400 method in that the J1400 measures sound transmission loss, and this document measures IL of body cavity materials in a cavity.
This document covers the useful frequency range of interest in 1/3 octave band center frequencies. The lower limit of the actual frequency range is limited by the size of the channel and/or the volume of the reverberation room. Two rectangular cross-section channels are cited in this standard. These are 75 mm × 75 mm and 150 mm × 150 mm in cross-section and provide valid data at and above 800 Hz and 400 Hz 1/3 octave band frequencies, respectively, provided the reverberation room can generate diffuse sound field at those frequencies.
Rationale
Content
Increased use of cavity filler materials on rockers, pillars, posts and other cavities has resulted in the need to develop a standardized procedure for rank ordering the performance of these materials in a controlled environment in the laboratory using a channel that simulates the application.
Meta TagsDetails
DOI
https://doi.org/10.4271/J2846_201005
Pages
10
Citation
SAE International Recommended Practice, Laboratory Measurement of the Acoustical Performance of Body Cavity Filler Materials, SAE Standard J2846_201005, Issued May 2010, https://doi.org/10.4271/J2846_201005.
Additional Details
Publisher
Published
May 26, 2010
Product Code
J2846_201005
Content Type
Recommended Practice
Status
Issued
Language
English

Revisions