J1304_201110 Cutting Edge - Cross Sections Loader Straight with Bolt Holes

Stabilized

10/25/2011

Features
Issuing Committee
Scope
Content
For cutting edges used on buckets for loaders defined in SAE J1057a. The dimensions are applicable to rolled and machined sections only. Cutting edge cross section thickness is limited to a maximum of 35 mm. Bolt-on tooth adapters are rarely used on loader buckets with cutting edge thicknesses in excess of 35 mm. This recommended practice applies only to straight cutting edges defined as those whose leading edge and rear edge are parallel and thus are of constant cross section. Overall cross sections to which bolt holes were added as indicated by this recommended practice were selected from those indicated per "Cutting Edge—Cross Sections Loader Straight," SAE J1303 FEB85. Selection was based on minimum section width requirements to accommodate bolt-on tooth adapters.
NOTE—For some heavy-duty applications, cross sections with larger blunts, greater bevel angles, and larger bolt holes may be required.
Meta TagsDetails
DOI
https://doi.org/10.4271/J1304_201110
Pages
3
Citation
SAE International Recommended Practice, Cutting Edge - Cross Sections Loader Straight with Bolt Holes, SAE Standard J1304_201110, Stabilized October 2011, Issued February 1985, https://doi.org/10.4271/J1304_201110.
Additional Details
Publisher
Published
Oct 25, 2011
Product Code
J1304_201110
Content Type
Recommended Practice
Status
Stabilized
Language
English

Revisions