J117_197001 DYNAMIC TEST PROCEDURE - TYPE 1 AND TYPE 2 SEAT BELT ASSEMBLIES
Issued
- Features
- Issuing Committee
- Content
- This SAE Recommended Practice establishes a dynamic test procedure for evaluating Type 1 lap belt assemblies for pelvic restraints and Type 2 assemblies for combination pelvic and upper torso restraints, as defined in SAE J4c. Uniform test requirements, test procedures, a seat belt assembly loading device, and data recording requirements are specified.The intent of the recommended practice is to provide an acceptance procedure employing a dynamic test method for determining the ability of seat belt assemblies to meet minimal requirements for restraining a seat belt assembly loading device. A simple dynamic test is described which will yield repeatable and comparable results while simulating the loading condition a seat belt assembly is subjected to in a frontal accident. The impact conditions generate belt loads representative of those obtained in a motor vehicle striking a rigid barrier head on at 30 mph as stated in SAE J850.
- Pages
- 2
- Citation
- SAE International Recommended Practice, DYNAMIC TEST PROCEDURE - TYPE 1 AND TYPE 2 SEAT BELT ASSEMBLIES, SAE Standard J117_197001, Issued January 1970, https://doi.org/10.4271/J117_197001.