Results
This AIR provides information about the specific requirements for missile hydraulic pumps and their associated power sources.
This SAE Aerospace Standard (AS) establishes the requirements for a V-band grooved clamp couplings that are intended for use on fluid-line tubing joints, tailpipe joints, and accessory mount joints, on flight vehicles or other attachments. The semi-rigid coupling joint assemblies, hereafter referred to as “the joint”, shall operate within the temperature ranges specified in their applicable part standards.
This specification covers a premium aircraft-quality, corrosion-resistant steel in the form of sheet, strip, and plate.
This specification covers a copper-zinc alloy (brass) in the form of laminated sheet with nominal thickness 0.006 to 0.125 inch (0.15 to 3.18 mm) (see 8.5).
This specification covers steel cleanliness requirements for premium aircraft-quality ferromagnetic steels, including hardenable, corrosion-resistant steels, by magnetic particle inspection methods. This specification contains sampling, sample preparation, inspection procedures, and cleanliness rating criteria (see 8.2).
This specification covers an aluminum alloy in the form of sand, investment, permanent mold, and composite mold castings with nominal wall thicknesses of up to 1.0 inch (25.4 mm), inclusive (see 8.8).
This specification covers a 100% homopolymer of polychlorotrifluoroethylene (PCTFE) in the form of molded sheet 0.250 inch (6.35 mm) and under in nominal thickness.
This specification covers a leaded bronze in the form of sand and centrifugal castings (see 8.6).
This SAE Standard covers a single Un-Jacketed (UTP) and Jacketed (J-UTP) Balanced Unshielded Twisted Pair data cable intended for use in surface vehicle cables for 10 Mb/s Ethernet shared bus applications. The tests in this document are intended to qualify cables for normal operation in an automotive environment while maintaining the necessary electrical properties for reliable data transmission.
This specification covers an aluminum alloy in the form of welding wire.
This specification covers an aluminum alloy in the form of rolled or cold-finished bars, rods, and wire and of flash-welded rings and stock for flash-welded rings.
This SAE Standard was developed to provide a method for indicating the direction of engine rotation and numbering of engine cylinders. The document is intended for use in designing new engines to eliminate the differences which presently exist in industry.
This specification covers an unfilled polyimide plastic in the form of molded rod and bar.
This specification covers a 100% homopolymer of polychlorotrifluoroethylene (PCTFE) in the form of rods, sheets, and molded shapes.
This specification covers the requirements for electrodeposited hard chromium plate.
This specification covers the specific requirements for 6061 aluminum alloy plate and sheet.
The scope of this document is to define a test method for performing the Compression Stress Relaxation (CSR) Test with the Automotive Standard (ASD) or HP CSR Jig using the appropriate test fixtures, configurations, and procedures. This standard defines the equipment needed, guidelines for running the test, and the format for generating the results and analyzing the data.
This SAE Recommended Practice provides procedures and methods for testing service, spring applied parking, and combination brake actuators with respect to durability, function, and environmental performance. A minimum of six test units designated A, B, C, D, E, and F are to be used to perform all tests per 1.1 and 1.2.
Items per page:
50
1 – 50 of 215951