Numerical Study on the Design of a Passive Pre-Chamber for a Heavy-Duty Hydrogen Combustion Engine
2024-01-2112
04/09/2024
- Features
- Event
- Content
- Lean-burn hydrogen internal combustion engines are a good option for future transportation solutions since they do not emit carbon-dioxide and unburned hydro-carbons, and the emissions of nitric-oxides (NOx) can be kept low. However, under lean-burn conditions the combustion duration increases, and the combustion stability decreases, leading to a reduced thermal efficiency. Turbulent jet ignition (TJI) can be used to extend the lean-burn limit, while decreasing the combustion duration and improving combustion stability. The objective of this paper is to investigate the feasibility of a passive pre-chamber TJI system on a heavy-duty hydrogen engine under lean-burn conditions using CFD modelling. The studied concept is mono-fuel, port-fuel injected, and spark ignited in the pre-chamber. The overall design of the pre-chamber is discussed and the effect of design parameters on the engine performance are studied. From this analysis, it was found that the volume of the pre-chamber and the area of the pre-chamber holes have major impact on the performance of the pre-chamber. Next, the difference between a regular spark-ignited combustion and a TJI system are investigated at a medium load point. The combustion duration is shortened significantly using a passive pre-chamber. However, the heat transfer loss through the walls increased significantly due to prolonged higher temperatures and higher turbulence near the combustion chamber walls. Finally, the air-fuel ratio is increased to study its effect on the heat transfer loss and NOx emissions.
- Pages
- 13
- Citation
- Maas, R., Bekdemir, C., and Somers, B., "Numerical Study on the Design of a Passive Pre-Chamber for a Heavy-Duty Hydrogen Combustion Engine," SAE Technical Paper 2024-01-2112, 2024, https://doi.org/10.4271/2024-01-2112.