Numerical Analysis of Advanced Battery Thermal Management Systems Using Nano-Enhanced Coolants

2026-28-0868

To be published on 11/25/2026

Features
Event
Authors
Abstract
Content
The current research gives a thorough transient numerical study of the conjugate effects between hydrodynamic flow of a nanofluid within a lithium-ion battery liquid cooling pack and its corresponding thermal management. Parallel micro-channel liquid cooling has recently been recognized as a critical thermal management system that will assist in local hotspot mitigation and prevent thermal runaway in electric vehicles as energy density of batteries continues to increase. In this research a 2D sandwich configuration consisting of a single central 2 mm fluid channel located between two solid heat-generating battery blocks was simulated over a 10s transient window with a time dependent solver. The effect of several volume fractions (ф= 0, 0.01,0.02, and 0.04) of dispersed nanoparticles was analyzed with a parametric study that was used in conjunction with the conjugate heat transfer and fluid dynamics behavior. The numerical domain was constructed with a highly optimized physics-controlled mesh with dense boundary layer elements located at the channel walls in order to capture any steep velocity and thermal gradients and also increase convergence when modelling very short transient periods. It can be seen that there is a very strong coupling effect occurring between flow behavior, pressure drop, and the system's thermal performance. Hydrodynamically, the flow rapidly moves through the transient inertia initial stage of the simulation to a consistent parabolic velocity profile whose peak center line velocity reaches 0.15m/s at steady state, which confirms typical fully developed laminar Hagen-Poiseuille flow with a no-slip wall boundary condition and a 0.1m length of fully developed flow. The asymmetric deviation that occurs at approximately 2s shows how quickly the flow's shear stress adjusted before the stead-state advection brought the centre velocity into a parabolic profile. The velocity profile subsequently affects the fluid's pressure field; the system's pressure drops linearly across the 0.1 m length, with a max pressure drop at the inlet of 41.2Pa which reduces to 0.44 Pa at the outlet and the peak in pressure contour clustering at the hydrodynamic entrance. Thermally the solid battery domains demonstrate a quick increase from a baseline 200C which begins to taper off until thermal equilibrium between internal heat generation and convective heat removal from the pack is reached. A significant advantage in the system's thermal behavior is seen as the volume fraction of added nanoparticles is increased; the peak temperature profiles decrease with increasing volume fraction until the 4% case effectively eliminates the localized battery hotspots. This is due to the basic premise of the Maxwell model; the high conductivity solid nanoparticles added to the fluid increases the thermal conductivity of the bulk coolant fluid and thins the thermal boundary layer, reducing interface thermal resistance. The drawback to adding nanoparticles to the system; however, is the increase in hydraulic penalty experienced by the system. Addition of nanoparticles increases bulk fluid viscosity and density, causing a steeper pressure gradient. In this system, the final result of 4% Nanofluid gives the biggest increase in safety margin as far as extending the life of the battery and reducing capacity fade, but there is a critical trade-off between this performance metric and additional pump energy needed by the system.
Meta TagsDetails
Citation
P., G., Neelima, K., Satyam, S., and Sudarmani, R., "Numerical Analysis of Advanced Battery Thermal Management Systems Using Nano-Enhanced Coolants," 9th SAENIS TTTMS International Conference 2026, Roorkee, India, December 3, 2026, .
Additional Details
Publisher
Published
To be published on Nov 25, 2026
Product Code
2026-28-0868
Content Type
Technical Paper
Language
English