Integrated Thermoelectric Cooling and Heating Architecture for Lithium-Ion Battery Packs

2026-28-0846

To be published on 11/25/2026

Authors
Abstract
Content
Thermal management of lithium-ion battery packs becomes increasingly challenging at elevated ambient temperatures because the small temperature difference between the battery and surrounding air limits passive heat rejection. This study presents a compact thermoelectric thermal-management architecture developed for a light electric two-wheeler battery pack. Twenty-four thermoelectric modules are integrated between the battery module and finned enclosure walls through thermally conductive interfaces and heat spreaders. During cooling operation, the modules pump heat from the battery toward the enclosure. Reversal of the applied current polarity can theoretically reverse the heat-transfer direction and provide battery heating; however, heating operation was not evaluated through simulation or experiment in the present study. A coupled electrothermal model was developed to represent battery heat generation, conductive heat-transfer paths, thermoelectric behaviour, hot-side heat rejection, and temperature-based hysteresis control. Pack-level hardware instrumented with fourteen temperature sensors was evaluated during representative discharge and charging operation. The experiments used continuous thermoelectric operation during discharge and constant-current charging rather than the simulated hysteresis strategy. The measured temperature envelope and simulated battery-temperature response showed comparable trends under the investigated conditions. Based on cumulative heat-rejection and electrical-energy values extracted from the experimental results, the estimated phase-average cooling coefficient of performance was close to 1.0 during discharge and approximately 0.35 during constant-current charging. The substantially lower charging-phase coefficient of performance demonstrates the increased parasitic energy penalty associated with higher temperature-lift operation. Thermoelectric-system efficiency was therefore strongly influenced by cold-side temperature, operating current, and hot-side heat rejection. The proposed architecture is primarily applicable to compact and modular light-electric-vehicle battery packs with moderate thermal loads. Further work is required to validate closed-loop control, evaluate heating operation, verify coefficient of performance using raw energy data, and assess scalability to larger electric-vehicle battery packs.
Meta TagsDetails
Citation
Kushwaha, S., Gavhane, S., Poreddy, K., and Garg, M., "Integrated Thermoelectric Cooling and Heating Architecture for Lithium-Ion Battery Packs," 9th SAENIS TTTMS International Conference 2026, Roorkee, India, December 3, 2026, .
Additional Details
Publisher
Published
To be published on Nov 25, 2026
Product Code
2026-28-0846
Content Type
Technical Paper
Language
English