IC Engine Internal Cooling System Modelling Using 1D-CFD Methodology

2020-01-1168

04/14/2020

Event
WCX SAE World Congress Experience
Authors Abstract
Content
Internal combustion engine gets heated up due to continuous combustion of fuel. To keep engine working efficiently and prevent components damage due to very high temperature, the engine needs to be cooled down. Based on power output requirement and provision for cooling system, every engine has it’s unique cooling system. Liquid based cooling systems are majorly implemented in automobile. It’s important to keep in mind that during design phase that, cooling the engine will lower the power to fuel consumption ratio. Therefore, during lower ambient conditions, the cooling system should be able to uniformly increase the temperature of the engine components, engine oil and transmission oil. This is achieved by circulating the coolant through cooling jacket, engine oil heater and transmission oil heater, which will be heated by the combustion heat. The objective of this study is to build a steady state 1D-model of cooling system; comprising of water pump, cooling jacket, engine head, thermostat, radiator, cabin heater, engine and transmission oil heaters with plumbing system. This 1D model is used to simulate vehicle drive cycle virtually. The whole model is validated with the actual vehicle testing. The drive cycle conditions are simulated in the form of transient simulation of 1D model by setting boundary conditions as per the engine speed and heat transfer of individual heat exchangers in the cooling system. The coolant flow numbers from both, vehicle test and 1D simulation are then compared. The 1D model is ensured to have +/- 10% deviation from the simulation and vehicle test results. This correlated 1D model can be used as the baseline for further development of engine cooling system in the future.
Meta TagsDetails
DOI
https://doi.org/10.4271/2020-01-1168
Pages
6
Citation
Autade, D., Kumar, A., Arthanari, T., Patil, V. et al., "IC Engine Internal Cooling System Modelling Using 1D-CFD Methodology," SAE Technical Paper 2020-01-1168, 2020, https://doi.org/10.4271/2020-01-1168.
Additional Details
Publisher
Published
Apr 14, 2020
Product Code
2020-01-1168
Content Type
Technical Paper
Language
English