This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Impulse Testing of Hydraulic Hose, Tubing, and Fittings Assemblies
- Aerospace Standard
Published June 19, 2008 by SAE International in United States
This Aerospace Recommended Practice (ARP) establishes the requirements and procedures for impulse testing of hose, tubing, and fitting assemblies for use in aerospace systems of 8000 psi nominal operating pressure or less. It also refers to standard impulse test equipment to be used in conducting these impulse tests.
ARP603 has been replaced with AS603 and therefore should be cancelled.
|Aerospace Standard||Impulse Testing of Hydraulic Tubing and Fittings, S-N Curve|
|Aerospace Standard||Hose Assembly, Polytetrafluoroethylene, Metallic Reinforced, 4000 psi, 400 °F, Heavy Duty, Hydraulic and Pneumatic|
|Aerospace Standard||Across Hex Corner Dimension for Fluid Fittings and Nuts|
Data Sets - Support Documents
No Datasets Available
G-3, Aerospace Couplings, Fittings, Hose, Tubing Assemblies
This Committee is responsible for developing and maintaining standards for design, test, and procurement of fluid systems part standards to improve reliability and economy. Their primary focus is on AS standards development and support of military standards. The Committee also develops ISO standards in a Subcommittee Advisory Group (SCAG) to ISO/TC 20/SC 10, and SAE-MA derivatives thereof.Structure: SAE G-3 -- Parent committee SAE G-3A -- Aerospace Couplings Subcommittee SAE G-3B -- Aerospace Fittings Subcommittee SAE G-3D -- Aerospace Hose Subcommittee SAE G-3E - Aerospace Tubing Assemblies Subcommittee U.S. SCAG to ISO/TC 20/SC 10 -- ISO standards Major projects: Support of Military Standards Reform Support of military standard conversions to MIL-PERF and MIL-DTL. Development of AS replacements for military standards designated for conversion. Establish document to list G-3 accepted replacements for replaced part standards and military back-up specifications. Development of PRI QML/QPL Development of Performance Review Institute (PRI) process for approval and surveillance of manufacturers (Qualified Manufacturer List, QML) and for approval of standard parts as qualified for use (Qualified Parts List, QPL). Development of ISO Standards, Imperial Units ISO/TC 20/SC 10 standards have typically been developed in SI units. The ISO has approved development of inch-based ISO standards to support commercial aviation. Basic design, test, and procurement specifications will be selected from military standards that are to be converted to Non-Government standard (NGS) and developed as ISO standards.
|AIR1228||Standard Impulse Machine Equipment and Operation|
|ISO6772||This document is not part of the subscrption.|
|MA2002||IMPULSE TESTING OF HYDRAULIC HOSE, TUBING AND FITTING ASSEMBLIES|
|MIL-L-7808||This document is not part of the subscrption.|
|MIL-M-83282||This document is not part of the subscrption.|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.