This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Photometric Data Acquisition Procedures for Impact Test
- Aerospace Standard
- ARP5482A
- Stabilized
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Aerospace Recommended Practice (ARP) defines the test set-up requirements, general analysis procedures, and test report documentation for impact tests where photometric analysis of the high speed film or digital video will be required to obtain target paths (typically the Anthropomorphic Test Dummy (ATD) head path and knee path). Such tests support the requirements of AS8049 - Performance Standard for Seats in Civil Rotorcraft, Transport Aircraft and General Aviation Aircraft.
These setup and analysis procedures are applicable to conventional, geometry based, two-dimensional analysis. If a more sophisticated technique that allows cameras to be installed at oblique angles for two or three-dimensional analysis is used, then the specific procedures required by that technique supersede any conflicting procedures contained herein. Some of the requirements that could be superseded include camera placement, optical data channel evaluation, camera to subject measurements, and scaling procedures.
Rationale
This document has been determined to contain basic and stable technology which is not dynamic in nature.
Recommended Content
Topic
Data Sets - Support Documents
No Datasets Available
Issuing Committee
The Aerospace Council of SAE established the Aircraft Seat Committee (SEAT) in 1997 to address technical issues related to the design and/or performance of aircraft seating systems. The seating systems include crew, flight attendants, and passenger seats installed in Civil Rotorcraft, Transport Aircraft, and General Aviation Aircraft.
A list of the technical reports developed by the SEAT Committee can be obtained by searching on 'aircraft seat' and selecting 'standards', from the SAE Home Page. SEAT StandardsReference
| Number | Title |
|---|---|
| J211-2 | This document is not part of the subscrption. |
| J211/2_201406 | Instrumentation for Impact Test—Part 2: Photographic Instrumentation |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.