This content is not included in your SAE MOBILUS subscription, or you are not logged in.
INSPECTION OF WORN INVOLUTE SPLINES
- Aerospace Standard
Published February 01, 1984 by SAE International in United States
This concept for measuring worn splines provides a direct wear depth dimension by utilizing the unworn involute surface as a contact point from which to measure the depth of wear on the spline tooth at the pitch diameter. Fig. 1 shows spline wear patterns and pitch diameter gaging points.
|Aerospace Standard||CIRCULAR SPLINE AND ADAPTER DETAILS ENGINE DRIVEN ACCESSORIES|
|Ground Vehicle Standard||Graphics - Based Service Information|
Data Sets - Support Documents
No Datasets Available
EG-1 Aerospace Propulsion Systems Support Equipment
Welcome to the EG-1, Aerospace Propulsion Systems Support Equipment Discussion Forum.Scope: Applies standardization principles where possible and develops guidance for new designs that further the advancement of support equipment for propulsion systems. Primary activities include development of industry standards, recommended practices, and technical information reports on support equipment and facilities related to gas turbine engine testing, balancing, engine accessory testing, inspection, packaging, handling and transportability. Standares for high performance hand tools for aerospace use are also developed by EG-1. Subcommittees: Technical Committee EG-1 operates using the following active subcommittees: EG-1A, Balancing EG-1B, Hand Tools EG-1E, Test Cells
|ASAB5.15||This document is not part of the subscrption.|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.