This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Agricultural Tractor Test Code
- Ground Vehicle Standard
Published May 15, 2003 by SAE International in United States
The purpose of this SAE Standard is to define test conditions, give a description of the tests to be made, specify data to be obtained, show formulas and calculations, define terms, and establish a uniform method of reporting so that performance data obtained on various makes and models of tractors, tested in accordance with this document, will be comparable regardless of where the test is made. It is obvious, because of the many present day tractor models available in a number of types with numerous items of special or optional equipment, that the scope of this document must be limited to obtaining and reporting only the most significant of widely used performance data. Outline of Code Section 3 Definitions Section 4 Test Conditions Section 5 Detailed Description of Test Procedure 5.1 Preparation of Tractor for Performance Runs 5.2 Mechanical Power Outlet Performance 5.2.1 Maximum Power Fuel Consumption 5.2.2 Varying Power Fuel Consumption 5.2.3 Power at Standard Power Take-Off Speed (This run is made only when the engine speed at SAE standard power take-off speed does not correspond to the engine speed at the maximum power run (5.2.1).) 5.3 Drawbar Performance 5.3.1 Maximum Drawbar Power 5.3.2 Varying Drawbar Power Fuel Consumption, Including Sound Level at Operator Station 5.3.3 Drawbar Pull Versus Travel Speed 5.3.4 Exterior Sound Level Section 6 Final Inspection Section 7 Calculations and Formulas Section 8 Uniform Method of Publishing Results
|Ground Vehicle Standard||Test Procedure for Measuring Hydraulic Lift Capacity on Agricultural Tractors Equipped with Three-Point Hitch|
|Ground Vehicle Standard||Safety Chain of Full Trailers or Converter Dollies|
|Ground Vehicle Standard||Trailer Couplings, Hitches, and Safety Chains—Automotive Type|
Data Sets - Support Documents
No Datasets Available
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.