This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Cargo Stopper Devices
- Aerospace Standard
Published July 06, 2011 by SAE International in United States
Downloadable datasets availableAnnotation ability available
The purpose of this SAE Aerospace Standard (AS) is to standardize the basic design, performance and testing requirements for “Cargo Stoppers” cargo tie-down accessories to be used in conjunction with approved tie-down straps meeting AS5385C (TSO C-172) requirements.
This Aerospace Standard was prepared in order to replace former Aerospace Recommended Practice ARP6022, developed in order to specify basic design, performance and testing requirements for cargo tie-down accessories known as “Cargo Stoppers”, which are commonly used but were not defined in any applicable standard. Sub-committee AGE-2A determined that, because these devices were used as part of tie-down arrangements meeting airworthiness criteria, they should be covered by a standard rather than a recommendation. The only technical changes are added flammability requirements.
|Aerospace Material Specification||Packaging and Identification of Molded Elastomeric Seals and Sealing Components|
|Aerospace Standard||SEAL, TYPE I & II STANDARD AND LOW PROFILE|
|Aerospace Standard||Wrenching Configuration, 12 Spline, For Metric Threaded Fasteners|
Data Sets - Support Documents
|Unnamed Dataset 1|
|Unnamed Dataset 2|
|Unnamed Dataset 3|
Committee AGE-2 reports to the Aerospace General Projects Division. The main, or governing committee, AGE-2, is composed of the most experienced members, mainly from the airlines, airframe manufacturers, and support equipment manufacturers, to provide leadership and guidance for the Membership to implement the work is drawn with reasonable balance from airlines, airframe manufacturers, support equipment manufacturers, and others with special aircraft related expertise. Members serve based on their knowledge, expertise, and experience and not as agents or representatives of any organization.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.