This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A Root Cause Investigation of Cylinder Head Cracking in Large Diesel Engine Standby Power Generators
Annotation ability available
Sector:
Language:
English
Abstract
Cylinder head cracking has been an engine development problem since the first high Performance diesels were designed and manufactured in the early 20th century. Valve bridge cracking is a common failure mode that is very dependent on engine application and operating conditions. Cracking failures cause increased engine maintenance and downtime, costly part replacement and in rare cases catastrophic engine failure. Cylinder head cracking continues to be problematic for modern diesel engines as peak firing pressures increase to meet exhaust emissions legislation and BMEPs increase for improved power density.
The root cause of cylinder head cracking is often difficult to diagnose due to large number of design, manufacturing and engine operational variables involved. This paper summarizes the methods, results and conclusions of a study to determine the root cause of cracking in cylinder heads of large diesel engines used for standby power generation in nuclear plants. The root cause study included investigative, analytical and engine testing activities.
The study revealed that head cracking was primarily affected by the seat insert counterbore design, fire deck thickness, engine load, and casting anomalies adjacent to the cracked locations. Recommendations to extend the service life of the cylinder head are discussed.
Recommended Content
Authors
Topic
Citation
Vertin, K., Haller, C., and Lubnow, T., "A Root Cause Investigation of Cylinder Head Cracking in Large Diesel Engine Standby Power Generators," SAE Technical Paper 950518, 1995, https://doi.org/10.4271/950518.Also In
References
- Haller, C.L. et.al. “Evaluation of Cracking in Cooper-Bessemer Model KSV Diesel Engine Power Heads” 1993
- French, C.C.J. “Problems Arising from the Water Cooling of Engine Components” Proc. IMechE London 184 29 1969 70
- Shalev, M. Zvivin, Y. Stotter, A. “Experimental and Analytical Investigation of Heat Transfer and Thermal Stresses in a Cylinder Head of a Diesel Engine” Int. J. Mech. Sci. 25 7 1983
- Smith, L.W.L. Angus, H.T. Lamb, A.D. “Cracking in Cast Iron Diesel Engine Cylinder Heads” Proc. IMechE 1 5.58 1970 71
- Helmich, M.J. Ulrey, C.S. “Design and Development of KSV Engine” Trans. of the ASME: Journal of Engineering for Power 1963
- Blech, J.J. “Heat Transfer and Stress Analyses of Engine Heads and Evaluation of Methods of Preventing Head Cracks” SAE Technical Paper No. 820504 1982
- Houston Light and Power “Cracked Heads on ESF DG#23” Significant Problem Investigation Report No. H880200 1988
- Haller, C.L. et. al. “Cooper-Bessemer Owner's Group Report on Testing of Cooper-Bessemer Model KSV-12-GDT Engine in Support of 1994 Technical Tasks” 1994
- Morel, T. Keribar, R. Blumberg, P “A New Approach to Integrating Engine Performance and Component Design Analysis Through Simulation” SAE Technical Paper No. 880131 1988
- Morel, T. Keribar, R. “A Model for Predicting Spatially Resolved Convective Heat Transfer in Bowl-in-Piston Combustion Chambers” SAE Technical Paper No. 850204 1985
- Nozue, Y. Satoh, H. Umetani, S. “Thermal Stress and Strength Prediction of Diesel Engine Cylinder Head” SAE Technical Paper 830148 1983