This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Investigation on Dynamic Response of a Closed Fuel Injector in a Diesel Engine at Low Speed
Annotation ability available
Sector:
Language:
English
Abstract
Contemporary high speed diesel engines require a compromise regarding the size of fuel nozzle orifices which should be small enough to assure a good fuel atomization at low engine speed, and large enough to provide the engine with high fuel dose at maximum power. Calculations were made to predict the dynamic response of a closed diesel injector within its unstable operation range. The pressure in the seat chamber under the needle was established as the key factor to simulate the injector's behaviour. It was measured at different flow conditions and used in calculations. After applying an optimization method, it was possible to predict how the design parameters of an injector should be changed in order to obtain the best dimentional configuration which improves the fuel atomization at low engine speed. The proposed method of injector simulation and optimization can be used to better adapt the closed multi-hole injectors to a diesel engine in cases xjhen the atomization of fuel at starting and idling conditions is not adequate.
Authors
Topic
Citation
Krepec, T., To, C., and Lisio, C., "Investigation on Dynamic Response of a Closed Fuel Injector in a Diesel Engine at Low Speed," SAE Technical Paper 880297, 1988, https://doi.org/10.4271/880297.Also In
References
- Burman, P.G. DeLuca, F. “Fuel Injection and Controls in Internal Combustion Engines.” The Technical Press London 1962
- Woodward, H.E “Factors Affecting Nozzle Chatter.” Technical Bulletin, BICERA 1963
- Hofken, W. “Der Einfluss der baulichen Auslegung von Einspritzventilen auf das Schnarrverhalten der Ventilnadel.” Motor-technische Zeitschrift 24 1 1963
- Pischinger, A. “Gemischbildung und Ver-brennung im Dieselmotor.” Springer Verlag Mien 1957
- Blaum, E. “Das Einspritzgesetz der Schnellaufenden Diesel maschine.” VDI-Verlag Berlin 1942
- Knight, B.E. “Fuel Injection System Calculations.” Proceedings of I.Mech.Eng. 1 1960-1961
- Becchi, G.A. “Analytical Simulation of Fuel Injection in Diesel Engines.” SAE Paper No. 710568
- Wylie, E.B. Bold, J.A. El-Erian, M.F. “Diesel Fuel Injection System Simulation and Experimental Correlation.” SAE Paper No. 710569
- To, C.H. “An Analytical and Experimental Study on Diesel Injectors Design.” Concordia University, Mechanical Engineering Dept. Montreal 1986
- McCloy, D. Martin, H.R. “The Control of Fluid Power.” Longman London 1973