This content is not included in your SAE MOBILUS subscription, or you are not logged in.
A Discussion of the Information Required on Spur and Helical Gear Drawings
ISSN: 0148-7191, e-ISSN: 2688-3627
Published September 01, 1984 by SAE International in United States
Annotation ability available
This paper presents a method of specifying the essential information for detailing the geometry of an external involute profiled spur or helical gear tooth. Internal gears are not included for reasons stated in the paper. It assumes that the reader is familiar with basic gear design terms and concepts.
|Technical Paper||Gear Design As Related to Gear Tooth Surface Failures|
|Technical Paper||The Quest for the Ultimate in Gear Load Carrying Capacity|
|Technical Paper||Designing Planetary Gears to Operate with Low Viscosity Synthetic Lubricants|