This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Modeling Transient Control of a Turbogenerator on a Drive Cycle
Abstract:
GTDI engines are becoming more efficient, whether individually or part of a HEV (Hybrid Electric Vehicle) powertrain. For the latter, this efficiency manifests itself as increase in zero emissions vehicle mileage. An ideal device for energy recovery is a turbogenerator (TG), and, when placed downstream the conventional turbine, it has minimal impact on catalyst light-off and can be used as a bolt-on aftermarket device. A Ricardo WAVE model of a representative GTDI engine was adapted to include a TG (Turbogenerator) and TBV (Turbine Bypass Valve) with the TG in a mechanical turbocompounding configuration, calibrated using steady state mapping data. This was integrated into a co-simulation environment with a SISO (Single-Input, Single-Output) dynamic controller developed in SIMULINK for the actuator control (with BMEP, manifold air pressure and TG pressure ratio as the controlled variables). Transient verification with WAVE-RT was conducted on WLTP and NEDC drive cycles, estimating dynamic energy recovery and fuel consumption improvement. Hints are given for a more advanced MIMO (Multiple-Input, Multiple-Output) control system architecture and calibration.
Recommended Content
| Technical Paper | A Parallel Hybrid Drivetrain |
| Magazine Issue | Automotive Engineering International 2002-02-01 |
| Technical Paper | 48V Boost Recuperation Systems - Golden Gate into the Future |