This content is not included in your SAE MOBILUS subscription, or you are not logged in.

The GTU: A New Realistic Generic Pickup Truck and SUV Model

Journal Article
2020-01-0664
ISSN: 2641-9645, e-ISSN: 2641-9645
Published April 14, 2020 by SAE International in United States
The GTU: A New Realistic Generic Pickup Truck and SUV Model
Citation: Woodiga, S., Howard, K., Norman, P., Lewington, N. et al., "The GTU: A New Realistic Generic Pickup Truck and SUV Model," SAE Int. J. Adv. & Curr. Prac. in Mobility 2(4):1986-1998, 2020, https://doi.org/10.4271/2020-01-0664.
Language: English

References

  1. Bureau of Economic Analysis, U.S. Department of Commerce https://www.bea.gov/docs/gdp/auto-and-truck-seasonal-adjustment Nov. 2019
  2. Le Good , G. and Garry , K. On the Use of Reference Models in Automotive Aerodynamics SAE Technical Paper 2004-01-1308 2004 https://doi.org/10.4271/2004-01-1308
  3. Heft , A. , Indinger , T. , and Adams , N. Introduction of a New Realistic Generic Car Model for Aerodynamic Investigations SAE Technical Paper 2012-01-0168 2012 https://doi.org/10.4271/2012-01-0168
  4. Peters , B. , Uddin , M. , Bain , J. , Curley , A. et al. Simulating DrivAer with Structured Finite Difference Overset Grids SAE Technical Paper 2015-01-1536 2015 https://doi.org/10.4271/2015-01-1536
  5. Ashton , N. and Revell , A. Comparison of RANS and DES Methods for the DrivAer Automotive Body SAE Technical Paper 2015-01-1538 2015 https://doi.org/10.4271/2015-01-1538
  6. Soares , R. and de Souza , F. Influence of CFD Setup and Brief Analysis of Flow Over a 3D Realistic Car Model SAE Technical Paper 2015-36-0513 2015 https://doi.org/10.4271/2015-36-0513
  7. Carrigan , T. , Landon , M. , and Pita , C. Meshing Considerations for Automotive Shape Design Optimization SAE Technical Paper 2016-01-1389 2016 https://doi.org/10.4271/2016-01-1389
  8. Jakirlic , S. , Kutej , L. , Hanssmann , D. , Basara , B. et al. Eddy-resolving Simulations of the Notchback ‘DrivAer’ Model: Influence of Underbody Geometry and Wheels Rotation on Aerodynamic Behaviour SAE Technical Paper 2016-01-1602 2016 https://doi.org/10.4271/2016-01-1602
  9. Soares , R. , Garry , K. , and Holt , J. Comparison of the Far-Field Aerodynamic Wake Development for Three DrivAer Model Configurations using a Cost-Effective RANS Simulation SAE Technical Paper 2017-01-1514 2017 https://doi.org/10.4271/2017-01-1514
  10. Simmonds , N. , Pitman , J. , Tsoutsanis , P. , Jenkins , K. et al. Complete Body Aerodynamic Study of three Vehicles SAE Technical Paper 2017-01-1529 2017 https://doi.org/10.4271/2017-01-1529
  11. Yu , X. , Jia , Q. , Bao , D. , and Yang , Z. A Comparative Study of Different Wheel Rotating Simulation Methods in Automotive Aerodynamics SAE Technical Paper 2018-01-0728 2018 https://doi.org/10.4271/2018-01-0728
  12. Ekman , P. , Larsson , T. , Virdung , T. , and Karlsson , M. Accuracy and Speed for Scale-Resolving Simulations of the DrivAer Reference Model SAE Technical Paper 2019-01-0639 2019 https://doi.org/10.4271/2019-01-0639
  13. Guilmineau , E. Numerical Simulations of Flow Around a Realistic Generic Car Model SAE Int. J. Passeng. Cars - Mech. Syst. 7 2 646 653 2014 https://doi.org/10.4271/2014-01-0607
  14. John , M. , Buga , S. , Monti , I. , Kuthada , T. et al. Experimental and Numerical Study of the DrivAer Model Aerodynamics SAE Technical Paper 2018-01-0741 2018 https://doi.org/10.4271/2018-01-0741
  15. Wieser , D. , Lang , H. , Nayeri , C. , and Paschereit , C. Manipulation of the Aerodynamic Behavior of the DrivAer Model with Fluidic Oscillators SAE Int. J. Passeng. Cars - Mech. Syst. 8 2 687 702 2015 https://doi.org/10.4271/2015-01-1540
  16. Soares , R. and de Souza , F. Proposal of an Aerodynamic Concept for Drag Reduction of Fastback Car Models SAE Technical Paper 2015-36-0523 2015 https://doi.org/10.4271/2015-36-0523
  17. Yuan , H. , Yang , Z. , and Li , Q. Effects of Installation Environment on Flow around Rear View Mirror SAE Int. J. Passeng. Cars - Mech. Syst. 10 2 580 590 2017 https://doi.org/10.4271/2017-01-1517
  18. Wittmeier , F. and Kuthada , T. Open Grille DrivAer Model - First Results SAE Int. J. Passeng. Cars - Mech. Syst. 8 1 252 260 2015 https://doi.org/10.4271/2015-01-1553
  19. Kuthada , T. , Wittmeier , F. , Bock , B. , Schoenleber , C. et al. The Effects of Cooling Air on the Flow Field around a Vehicle SAE Int. J. Passeng. Cars - Mech. Syst. 9 2 723 732 2016 https://doi.org/10.4271/2016-01-1603
  20. Collin , C. , Mack , S. , Indinger , T. , and Mueller , J. A Numerical and Experimental Evaluation of Open Jet Wind Tunnel Interferences using the DrivAer Reference Model SAE Int. J. Passeng. Cars - Mech. Syst. 9 2 657 679 2016 https://doi.org/10.4271/2016-01-1597
  21. Strangfeld , C. , Wieser , D. , Schmidt , H. , Woszidlo , R. et al. Experimental Study of Baseline Flow Characteristics for the Realistic Car Model DrivAer SAE Technical Paper 2013-01-1251 2013 https://doi.org/10.4271/2013-01-1251
  22. Wieser , D. , Schmidt , H. , Müller , S. , Strangfeld , C. et al. Experimental Comparison of the Aerodynamic Behavior of Fastback and Notchback DrivAer Models SAE Int. J. Passeng. Cars - Mech. Syst. 7 2 682 691 2014 https://doi.org/10.4271/2014-01-0613
  23. James , T. , Krueger , L. , Lentzen , M. , Woodiga , S. et al. Development and Initial Testing of a Full-Scale DrivAer Generic Realistic Wind Tunnel Correlation and Calibration Model SAE Int. J. Passeng. Cars - Mech. Syst. 11 5 353 367 2018 https://doi.org/10.4271/2018-01-0731
  24. Forbes , D. , Page , G. , Passmore , M. , and Gaylard , A. A Fully Coupled, 6 Degree-of-Freedom, Aerodynamic and Vehicle Handling Crosswind Simulation using the DrivAer Model SAE Int. J. Passeng. Cars - Mech. Syst. 9 2 710 722 2016 https://doi.org/10.4271/2016-01-1601
  25. Howell , J. , Forbes , D. , Passmore , M. , and Page , G. The Effect of a Sheared Crosswind Flow on Car Aerodynamics SAE Int. J. Passeng. Cars - Mech. Syst. 10 1 278 285 2017 https://doi.org/10.4271/2017-01-1536
  26. Josefsson , E. , Hagvall , R. , Urquhart , M. , and Sebben , S. Numerical Analysis of Aerodynamic Impact on Passenger Vehicles during Cornering SAE Technical Paper 2018-37-0014 2018 https://doi.org/10.4271/2018-37-0014
  27. Stoll , D. and Wiedemann , J. Active Crosswind Generation and Its Effect on the Unsteady Aerodynamic Vehicle Properties Determined in an Open Jet Wind Tunnel SAE Int. J. Passeng. Cars - Mech. Syst. 11 5 429 446 2018 https://doi.org/10.4271/2018-01-0722
  28. Soares , R. , Knowles , A. , Goñalons Olives , S. , Garry , K. et al. On the Aerodynamics of an Enclosed-Wheel Racing Car: An Assessment and Proposal of Add-On Devices for a Fourth, High-Performance Configuration of the DrivAer Model SAE Technical Paper 2018-01-0725 2018 https://doi.org/10.4271/2018-01-0725
  29. Zhang , C. , Tanneberger , M. , Kuthada , T. , Wittmeier , F. et al. Introduction of the AeroSUV-A New Generic SUV Model for Aerodynamic Research SAE Technical Paper 2019-01-0646 2019 https://doi.org/10.4271/2019-01-0646
  30. Lokhande , B. , Sovani , S. , and Khalighi , B. Transient Simulation of the Flow Field Around a Generic Pickup Truck SAE Technical Paper 2003-01-1313 2003 https://doi.org/10.4271/2003-01-1313
  31. Al-Garni , A. , Bernal , L. , and Khalighi , B. Experimental Investigation of the Flow Around a Generic SUV SAE Technical Paper 2004-01-0228 2004 https://doi.org/10.4271/2004-01-0228
  32. Yang , Z. and Khalighi , B. CFD Simulations for Flow Over Pickup Trucks SAE Technical Paper 2005-01-0547 2005 https://doi.org/10.4271/2005-01-0547
  33. Yang , Z. , Nastov , A. , and Schenkel , M. Further Assessment of Closed-Wall Wind Tunnel Blockage Using CFD SAE Technical Paper 2005-01-0868 2005 https://doi.org/10.4271/2005-01-0868
  34. Khalighi , B. Comparison Between the Conventional Body-Fitted and the Lattice Boltzmann CFD Methods for the Flow around a Generic Pickup Truck SAE Technical Paper 2008-01-0323 2008 https://doi.org/10.4271/2008-01-0323
  35. Zhu , H. and Yang , Z. Simulation of Flow around a Generic Pickup Truck with RSM Model SAE Technical Paper 2008-01-0324 2008 https://doi.org/10.4271/2008-01-0324
  36. Mokhtar , W. , Britcher , C. , and Camp , R. Further Analysis of Pickup Trucks Aerodynamics SAE Technical Paper 2009-01-1161 2009 https://doi.org/10.4271/2009-01-1161
  37. Holloway , S. , Leylek , J. , York , W. , and Khalighi , B. Aerodynamics of a Pickup Truck: Combined CFD and Experimental Study SAE Int. J. Commer. Veh. 2 1 88 100 2009 https://doi.org/10.4271/2009-01-1167
  38. Ha , J. , Jeong , S. , and Obayashi , S. Investigation of the Bed and Rear Flap Variation for a Low-Drag Pickup Truck using Design of Experiments SAE Technical Paper 2010-01-0122 2010 https://doi.org/10.4271/2010-01-0122
  39. Wang , H. , Lin , T. , Yuan , X. , and Zhang , Q. Simulation and Aerodynamic Optimization of Flow Over a Pickup Truck Model SAE Technical Paper 2014-01-2437 2014 https://doi.org/10.4271/2014-01-2437
  40. Wiedemann , J. and Potthoff , J. The New 5-Belt Road Simulation System of the IVK Wind Tunnels - Design and First Results SAE Technical Paper 2003-01-0429 2003 https://doi.org/10.4271/2003-01-0429
  41. Blumrich , R. , Widdecke , N. , Wiedemann , J. , Michelbach , A. et al. New FKFS Technology at the Full-Scale Aeroacoustic Wind Tunnel of University of Stuttgart SAE Int. J. Passeng. Cars - Mech. Syst. 8 1 294 305 2015 https://doi.org/10.4271/2015-01-1557
  42. Larson , L. and Woodiga , S. Aerodynamic Investigation of Cooling Drag of a Production Pickup Truck Part 1: Test Results SAE Int. J. Passeng. Cars - Mech. Syst. 11 5 477 491 2018 https://doi.org/10.4271/2018-01-0740
  43. Lietz , R. , Larson , L. , Bachant , P. , Goldstein , J. et al. An Extensive Validation of an Open Source Based Solution for Automobile External Aerodynamics SAE Technical Paper 2017-01-1524 2017 https://doi.org/10.4271/2017-01-1524
  44. Norman , P. and Howard , K.

Cited By