This content is not included in your SAE MOBILUS subscription, or you are not logged in.

A New Method for Measuring Fuel Flow in an Individual Injection in Real Time

Journal Article
2018-01-0285
ISSN: 1946-3936, e-ISSN: 1946-3944
Published April 03, 2018 by SAE International in United States
A New Method for Measuring Fuel Flow in an Individual Injection in Real Time
Sector:
Citation: Leach, F., Davy, M., Henry, M., Tombs, M. et al., "A New Method for Measuring Fuel Flow in an Individual Injection in Real Time," SAE Int. J. Engines 11(6):687-695, 2018, https://doi.org/10.4271/2018-01-0285.
Language: English

References

  1. Aradi , A. , Imoehl , B. , Avery , N. , Wells , P. et al. The Effect of Fuel Composition and Engine Operating Parameters on Injector Deposits in a High-Pressure Direct Injection Gasoline (DIG) Research Engine SAE Technical Paper 1999-01-3690 1999 10.4271/1999-01-3690
  2. Birgel , A. , Ladommatos , N. , Aleiferis , P. , Zülch , S. et al. Deposit Formation in the Holes of Diesel Injector Nozzles: A Critical Review SAE Technical Paper 2008-01-2383 2008 10.4271/2008-01-2383
  3. Pos , R. et al. Combustion of Ligaments and Droplets Expelled after the End of Injection in a Multi-Hole Diesel Injector Fuel 197 459 466 2017
  4. Leach , F. , Ismail , R. , Davy , M. , Weall , A. et al. Comparing the Effect of Fuel/Air Interactions in a Modern High-Speed Light-Duty Diesel Engine SAE Technical Paper 2017-24-0075 2017 10.4271/2017-24-0075
  5. Ferrari , A. and Mittica , A. Response of Different Injector Typologies to Dwell Time Variations and a Hydraulic Analysis of Closely-Coupled and Continuous Rate Shaping Injection Schedules Applied Energy 169 899 911 2016
  6. Jörg , C. , Schnorbus , T. , Jarvis , S. , Neaves , B. et al. Feedforward Control Approach for Digital Combustion Rate Shaping Realizing Predefined Combustion Processes SAE Int. J. Engines 8 3 1041 1054 2015 10.4271/2015-01-0876
  7. Arcoumanis , C. and Baniasad , M. Analysis of Consecutive Fuel Injection Rate Signals Obtained by the Zeuch and Bosch Methods SAE Technical Paper 930921 1993 10.4271/930921
  8. Marčič , M. Measuring Method for Diesel Multihole Injection Nozzles Sensors and Actuators A: Physical 107 2 152 158 2003
  9. Vass , S. and Németh , H. Sensitivity Analysis of Instantaneous Fuel Injection Rate Determination for Detailed Diesel Combustion Models Periodica Polytechnica. Transportation Engineering 41 1 77 2013
  10. Bower , G. and Foster , D. A Comparison of the Bosch and Zuech Rate of Injection Meters SAE Technical Paper 910724 1991 10.4271/910724
  11. Turner , J. , Popplewell , A. , Patel , R. , Johnson , T. et al. Ultra Boost for Economy: Extending the Limits of Extreme Engine Downsizing SAE Int. J. Engines 7 1 387 417 2014 10.4271/2014-01-1185
  12. Alriksson , M. , Rente , T. , and Denbratt , I. Low Soot, Low NOx in a Heavy Duty Diesel Engine Using High Levels of EGR SAE Technical Paper 2005-01-3836 2005 10.4271/2005-01-3836
  13. Hagena , J. , Filipi , Z. , and Assanis , D. Transient Diesel Emissions: Analysis of Engine Operation during a Tip-in SAE Technical Paper 2006-01-1151 2006 10.4271/2006-01-1151
  14. Lounici , M.S. et al. Towards Improvement of Natural Gas-Diesel Dual Fuel Mode: An Experimental Investigation on Performance and Exhaust Emissions Energy 64 200 211 2014
  15. Henry , M.P. et al. A Self-Validating Digital Coriolis Mass-Flow Meter: An Overview Control Engineering Practice 8 5 487 506 2000
  16. Henry , M.P. 2016
  17. Bosch Diesel-Engine Management Fifth Robert Bosch GmbH 2005
  18. Bardi , M. et al. Engine Combustion Network: Comparison of Spray Development, Vaporization, and Combustion in Different Combustion Vessels Atomization and Sprays 22 10 807 842 2012
  19. Payri , R. et al. A New Methodology for Correcting the Signal Cumulative Phenomenon on Injection Rate Measurements Experimental Techniques 32 1 46 49 2008
  20. Pickett , L. , Manin , J. , Payri , R. , Bardi , M. et al. Transient Rate of Injection Effects on Spray Development SAE Technical Paper 2013-24-0001 2013 10.4271/2013-24-0001
  21. Bosch Automotive Handbook Eighth Robert Bosch GmbH 2011
  22. Dahlstrom , J. , Andersson , O. , Tuner , M. , and Persson , H. Experimental Comparison of Heat Losses in Stepped-Bowl and Re-Entrant Combustion Chambers in a Light Duty Diesel Engine SAE Technical Paper 2016-01-0732 2016 10.4271/2016-01-0732
  23. Leach , F. , Stone , R. , and Richardson , D. The Influence of Fuel Properties on Particulate Number Emissions from a Direct Injection Spark Ignition Engine SAE Technical Paper 2013-01-1558 2013 10.4271/2013-01-1558
  24. Leach , F. et al. Predicting the Particulate Matter Emissions from Spray-Guided Gasoline Direct-Injection Spark Ignition Engines Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering 231 6 717 730 2017
  25. Mohd Murad , S. , Camm , J. , Davy , M. , Stone , R. et al. Spray Behaviour and Particulate Matter Emissions with M15 Methanol/Gasoline Blends in a GDI Engine SAE Technical Paper 2016-01-0991 2016 10.4271/2016-01-0991
  26. Fridriksson , H. , Tuner , M. , Andersson , O. , Sunden , B. et al. Effect of Piston Bowl Shape and Swirl Ratio on Engine Heat Transfer in a Light-Duty Diesel Engine SAE Technical Paper 2014-01-1141 2014 10.4271/2014-01-1141
  27. British Standards BS EN 590 Diesel 2009
  28. Henry , M. , O. Bushuev , and O. Ibryaeva Prism Signal Processing for Sensor Condition Monitoring IEEE International Symposium on Industrial Electronics Edinburgh, UK 2017
  29. Henry , M. et al. The Prism: Efficient Signal Processing for the Internet of Things IEEE Industrial Electronics Magazine 11 4 22 32 2017
  30. Leach , F. et al. Fast Coriolis Mass Flow Metering for Monitoring Diesel Fuel Injection Flow Measurement and Instrumentation 58 1 5 2017

Cited By