This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Software Test and Calibration Using Virtual Manufacturing
ISSN: 0148-7191, e-ISSN: 2688-3627
Published March 28, 2017 by SAE International in United States
Annotation ability available
This paper describes how distributive computing along with statistical subsystem simulation can be applied to produce near production ready embedded vehicle software and calibrations. Coupling distributive computing and statistical simulation was first employed over a decade ago at General Motors to design and analyze propulsion subsystem hardware. Recently this method of simulation has been enhanced extending its capabilities to both test embedded vehicle code as well as develop calibrations. A primary advantage of this simulation technique is its ability to generate data from a statistically significant population of subsystems. The result is the acquisition of an optimal data set enabling the development of a robust design now including both embedded code and calibrations. Additionally it has been shown that there are significant economic advantages in terms of time and cost associated with this type of development when compared to traditional method. The following section will describe in detail using examples and data the advantages of this innovative approach to software testing and calibration.
|Technical Paper||System Simulation and Prototyping|
|Book||Safety and Reliability in Cooperating Unmanned Aerial Systems|
|Technical Paper||Personal Computer Design Software for Magnetic Analysis and Dynamic Simulation of a Two-Valve Solenoid Actuator|
CitationGoodwin, W., Mancuso, C., and Brown, N., "Software Test and Calibration Using Virtual Manufacturing," SAE Technical Paper 2017-01-0536, 2017, https://doi.org/10.4271/2017-01-0536.
- Mantooth, H.A.; Vlach, M; Beyond SPICE with Saber and MAST, IEEE International Symposium on Circuits and Systems, 1992
- Brezina, Tomas; Jablonski, Ryszard; Mechatronics 2013: Recent Technological and Scientific Advances, Springer Science & Business Media, September 2013.
- Karnopp, Dean C.; Margolis Donald L.; Rosenberg, Ronald C.; System Dynamics Modeling, Simulation, and Control of Mechatronic Systems, Fifth Edition, John Wiley & Son, Inc Hoboken New Jersey; ©Copyright 2012
- Phadke Madhav S.: Quality Engineering Using Robust Design, Prentice Hall, ©1989 AT&T Bell Laboratories, Chaps. 1,2.
- Taguchi, Genichi; Chowdhury, Subir; Wu, Yuin; “Taguchi’s Quality Engineering” Hoboken, New Jersey: John Wileu & Saons, Inc,2005
- Goodwin, W., Bhatti, A., and Jensen, M., "Designing Automotive Subsystems Using Virtual Manufacturing and Distributed Computing," SAE Technical Paper 2008-01-0288, 2008, doi:10.4271/2008-01-0288.
- Poole, J., Patton, J., and Goodwin, B., "Modeling and Simulating a VVT System for Robust Design," SAE Technical Paper 2008-01-0901, 2008, doi:10.4271/2008-01-0901.