This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Design Challenges in the Development of a Large Vehicle Inertial Measurement System

Journal Article
2014-01-0096
ISSN: 1946-391X, e-ISSN: 1946-3928
Published April 01, 2014 by SAE International in United States
Design Challenges in the Development of a Large Vehicle Inertial Measurement System
Sector:
Citation: Every, J., Heydinger, G., Guenther, D., Sidhu, A. et al., "Design Challenges in the Development of a Large Vehicle Inertial Measurement System," SAE Int. J. Commer. Veh. 7(1):1-7, 2014, https://doi.org/10.4271/2014-01-0096.
Language: English

Abstract:

The (Vehicle Inertia Parameter Evaluation Rig) VIPER II is a full vehicle mass and inertia parameter measurement machine. The VIPER II expands upon the capabilities of its predecessor and is capable of measuring vehicles with a mass of up to 45,360 kg (100,000 lb), an increase in capacity of 18,100 kg (40,000 lb). The VIPER II also exceeds its predecessor in both the length and width of vehicles it can measure. The VIPER II's maximum vehicle width is 381 cm (150 in) an increase of 76 cm (30 in) and maximum distance from the vehicle CG to the outer most axle is 648 cm (255 in) an additional 152 cm (60 in)
The VIPER II is capable of performing measurements including vehicle CG height, pitch, roll, and yaw moments of inertia and the roll/yaw cross product of inertia. While being able to measure both heavier and larger vehicles, the VIPER II is designed to maintain a maximum error of 3% for all inertia measurements and 1% for CG height.
When designing a system with increased capacity there are many different factors and properties that must be considered. Some properties increase linearly when scaled such as mass but others such as moment of inertia and stiffness do not. This document presents some of the design challenges encountered in development of the VIPER II and how those challenges were addressed.