This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Boost System Development for Gasoline Direct-Injection Compression-Ignition (GDCI)

Journal Article
ISSN: 1946-3936, e-ISSN: 1946-3944
Published April 08, 2013 by SAE International in United States
Boost System Development for Gasoline Direct-Injection Compression-Ignition (GDCI)
Citation: Hoyer, K., Sellnau, M., Sinnamon, J., and Husted, H., "Boost System Development for Gasoline Direct-Injection Compression-Ignition (GDCI)," SAE Int. J. Engines 6(2):815-826, 2013,
Language: English


Intake boosting is an important method to improve fuel economy of internal combustion engines. Engines can be down-sized, down-speeded, and up-loaded to reduce friction losses, parasitic losses, and pumping losses, and operate at speed-load conditions that are thermodynamically more efficient. Low-temperature combustion engines (LTE) also benefit from down-sizing, down-speeding, and up-loading, but these engines exhibit very low exhaust enthalpy to drive conventional turbochargers. This paper describes modeling, evaluation, and selection of an efficient boost system for a 1.8L four-cylinder Gasoline Direct-Injection Compression-Ignition (GDCI) engine.
After a preliminary concept selection phase the model was used to develop the boost system parameters to achieve full-load and part-load engine operation objectives. The simulation was used to demonstrate that a practical boost system can provide the boost necessary at reasonable brake efficiency levels over the entire engine operating range. A comprehensive simulation based calibration was performed to determine the most efficient steady operation settings. Also a step change in speed/load engine operation was simulated to demonstrate the system transient response.