This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Visualization of Propane and Natural Gas Spark Ignition and Turbulent Jet Ignition Combustion

Journal Article
2012-32-0002
ISSN: 1946-3936, e-ISSN: 1946-3944
Published October 23, 2012 by SAE International in United States
Visualization of Propane and Natural Gas Spark Ignition and Turbulent Jet Ignition Combustion
Sector:
Citation: Toulson, E., Huisjen, A., Chen, X., Squibb, C. et al., "Visualization of Propane and Natural Gas Spark Ignition and Turbulent Jet Ignition Combustion," SAE Int. J. Engines 5(4):1821-1835, 2012, https://doi.org/10.4271/2012-32-0002.
Language: English

References

  1. Tully, E. Heywood, J. “Lean-Burn Characteristics of a Gasoline Engine Enriched with Hydrogen Plasmatron Fuel Reformer,” SAE Technical Paper 2003-01-0630 2003 10.4271/2003-01-0630
  2. Aleiferis, P. G. Hardalupas, Y. Taylor, A. M. K. P. Ishii, K. Urata, Y. “Flame chemiluminescence studies of cyclic combustion variations and air-to-fuel ratio of the reacting mixture in a lean-burn stratified-charge spark-ignition engine,” Combustion and Flame 136 1-2 72 90 2004
  3. Ayala, F. Heywood, J. “Lean SI Engines: The Role of Combustion Variability in Defining Lean Limits,” SAE Technical Paper 2007-24-0030 2007 10.4271/2007-24-0030
  4. Das, A. Watson, H. C. “Development of a Natural Gas Spark Ignition Engine for Optimum Performance,” Proceedings of the I MECH E Part D Journal of Automobile Engineering 211 361 378 1997
  5. Attard, W. Blaxill, H. “A Single Fuel Pre-Chamber Jet Ignition Powertrain Achieving High Load, High Efficiency and Near Zero NOx Emissions,” SAE Int. J. Engines 5 3 734 746 2012 10.4271/2011-01-2023
  6. Attard, W. Bassett, M. Parsons, P. Blaxill, H. “A New Combustion System Achieving High Drive Cycle Fuel Economy Improvements in a Modern Vehicle Powertrain,” SAE Technical Paper 2011-01-0664 2011 10.4271/2011-01-0664
  7. Toulson, E. Schock, H. Attard, W. “A Review of Pre-Chamber Initiated Jet Ignition Combustion Systems,” SAE Technical Paper 2010-01-2263 2010 10.4271/2010-01-2263
  8. Toulson, E. Watson, H. Attard, W. “Gas Assisted Jet Ignition of Ultra-Lean LPG in a Spark Ignition Engine,” SAE Technical Paper 2009-01-0506 2009 10.4271/2009-01-0506
  9. Lawrence, J. “Hydrocarbon Emission from a HAJI Equipped Ultra Lean Burn Engine, PhD Thesis,” The Department of Mechanical Engineering The University of Melbourne 1999
  10. Dale, J. D. Checkel, M. D. Smy, P. R. “Application of High Energy Ignition Systems to Engines,” Progress in Energy and Combustion Science 23 5-6 379 398 1997
  11. Attard, W. Fraser, N. Parsons, P. Toulson, E. “A Turbulent Jet Ignition Pre-Chamber Combustion System for Large Fuel Economy Improvements in a Modern Vehicle Powertrain,” SAE Int. J. Engines 3 2 20 37 2010 10.4271/2010-01-1457
  12. Attard, W. Blaxill, H. “A Lean Burn Gasoline Fueled Pre-Chamber Jet Ignition Combustion System Achieving High Efficiency and Low NOx at Part Load,” SAE Technical Paper 2012-01-1146 2012 10.4271/2012-01-1146
  13. Mittal, M. Hung, D. Zhu, G. Schock, H. “A Study of Fuel Impingement Analysis on In-Cylinder Surfaces in a Direct- Injection Spark-Ignition Engine with Gasoline and Ethanol-Gasoline Blended Fuels,” SAE Technical Paper 2010-01-2153 2010 10.4271/2010-01-2153
  14. Withrow, L. Bowditch, F. “Flame Photographs of Autoignition Induced by Combustion-Chamber Deposits,” SAE Technical Paper 520265 1952 10.4271/520265
  15. Lumsden, G. OudeNijeweme, D. Fraser, N. Blaxill, H. “Development of a Turbocharged Direct Injection Downsizing Demonstrator Engine,” SAE Int. J. Engines 2 1 1420 1432 2009 10.4271/2009-01-1503
  16. Heywood, J. B. Internal Combustion Engine Fundamentals McGraw-Hill 1988
  17. Quader, A. Kirwan, J. Grieve, M. “Engine Performance and Emissions near the Dilute Limit with Hydrogen Enrichment using an On-Board Reforming Strategy,” SAE Technical Paper 2003-01-1356 2003 10.4271/2003-01-1356
  18. Babrausak, V. Ignition Handbook Issaquah. WA Fire Science Publishers 2003
  19. Watson, H. C. Milkins, E. E. “Comparison and Optimization of Emission Efficiency and Power of Five Automotive Fuels in One Engine,” International Journal of Vehicle Design 3 4 1982
  20. Allgeier, T. Klenk, M. Landenfeld, T. Conte, E. et al. “Advanced Emission and Fuel Economy Concept Using Combined Injection of Gasoline and Hydrogen in SI-Engines,” SAE Technical Paper 2004-01-1270 2004 10.4271/2004-01-1270
  21. Attard, W. Parsons, P. “A Normally Aspirated Spark Initiated Combustion System Capable of High Load, High Efficiency and Near Zero NOx Emissions in a Modern Vehicle Powertrain,” SAE Int. J. Engines 3 2 269 287 2010 10.4271/2010-01-2196
  22. Attard, W. Parsons, P. “Flame Kernel Development for a Spark Initiated Pre-Chamber Combustion System Capable of High Load, High Efficiency and Near Zero NOx Emissions,” SAE Int. J. Engines 3 2 408 427 2010 10.4271/2010-01-2260
  23. Attard, W. Kohn, J. Parsons, P. “Ignition Energy Development for a Spark Initiated Combustion System Capable of High Load, High Efficiency and Near Zero NOx Emissions,” SAE Int. J. Engines 3 2 481 496 2010 10.4271/2010-32-0088
  24. Attard, W. Blaxill, H. “A Gasoline Fueled Pre-Chamber Jet Ignition Combustion System at Unthrottled Conditions,” SAE Int. J. Engines 5 2 315 329 2012 10.4271/2012-01-0386
  25. Gaydon, A. G. Wolfhard, H. G. Flames: Their Structure, Radiation and Temperature London Chapman and Hall 1978
  26. Kochar, Y. Seitzman, J. Liewen, T. Metcalfe, W. K. Burke, S. Curran, H. Krejci, M. Lowry, W. Petersen, E. L. Bourque, G. “Laminar Flame Speed Measurements and Modeling of Alkane Blends at Elevated Pressures with Various Diluents,” Proceedings of ASME Turbo Expo 2011 Vancouver, British Columbia, Canada 2011
  27. Lauer, M. Sattelmayer, T. “On the Adequacy of Chemiluminescence as a Measure of Heat Release in Turbulent Flames with Mixture Gradients,” Journal of Engineering for Gas Turbines and Power 132 2010
  28. Griffiths, J. F. Barnard, J. A. “Flame and Combustion 3rd edition,” Springer 1998 328

Cited By