Try Mobilus Beta
Search tips
 This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Ethanol/N-Heptane Dual-Fuel Partially Premixed Combustion Analysis through Formaldehyde PLIF

Journal Article
2012-01-0685
ISSN: 1946-3936, e-ISSN: 1946-3944
DOI: https://doi.org/10.4271/2012-01-0685
Published April 16, 2012 by SAE International in United States
Ethanol/N-Heptane Dual-Fuel Partially Premixed Combustion Analysis through Formaldehyde PLIF
Sector:
Citation: Florea, R., Zha, K., Yu, X., Jansons, M. et al., "Ethanol/N-Heptane Dual-Fuel Partially Premixed Combustion Analysis through Formaldehyde PLIF," SAE Int. J. Engines 5(2):483-492, 2012, https://doi.org/10.4271/2012-01-0685.
Language: English

References

  1. Huang, Y. Mehta, D. “Investigation of an In-cylinder Ion Sensing Assisted HCCI Control Strategy,” SAE Technical Paper 2005-01-0068 2005 10.4271/2005-01-0068
  2. Bengtsson, J. Strandh, P. Johansson, R. Tunestål, P. et al. “Multi-Output Control of a Heavy Duty HCCI Engine Using Variable Valve Actuation and Model Predictive Control,” SAE Technical Paper 2006-01-0873 2006 10.4271/2006-01-0873
  3. Epping, K. Aceves, S. Bechtold, R. Dec, J. “The Potential of HCCI Combustion for High Efficiency and Low Emissions,” SAE Technical Paper 2002-01-1923 2002 10.4271/2002-01-1923
  4. Yang, Y. Dec, J. Dronniou, N. Sjöberg, M. et al. “Partial Fuel Stratification to Control HCCI Heat Release Rates: Fuel Composition and Other Factors Affecting Pre-Ignition Reactions of Two-Stage Ignition Fuels,” SAE Int. J. Engines 4 1 1903 1920 2011 10.4271/2011-01-1359
  5. Splitter, D. Hanson, R. Kokjohn, S. Reitz, R. “Reactivity Controlled Compression Ignition (RCCI) Heavy-Duty Engine Operation at Mid-and High-Loads with Conventional and Alternative Fuels,” SAE Technical Paper 2011-01-0363 2011 10.4271/2011-01-0363
  6. Dunbeck, P. Reitz, R. “An Experimental Study of Dual Fueling with Gasoline Port Injection in a Single-Cylinder, Air-Cooled HSDI Diesel Generator,” SAE Technical Paper 2010-01-0869 2010 10.4271/2010-01-0869
  7. Hanson, R. Kokjohn, S. Splitter, D. Reitz, R. “An Experimental Investigation of Fuel Reactivity Controlled PCCI Combustion in a Heavy-Duty Engine,” SAE Int. J. Engines 3 1 700 716 2010 10.4271/2010-01-0864
  8. Splitter, D. Reitz, R. Hanson, R. “High Efficiency, Low Emissions RCCI Combustion by Use of a Fuel Additive,” SAE Int. J. Fuels Lubr. 3 2 742 756 2010 10.4271/2010-01-2167
  9. Vressner, A. Lundin, A. Christensen, M. Tunestål, P. et al. “Pressure Oscillations During Rapid HCCI Combustion,” SAE Technical Paper 2003-01-3217 2003 10.4271/2003-01-3217
  10. Hashimoto, K. “Effect of Ethanol on the HCCI Combustion,” SAE Technical Paper 2007-01-2038 2007 10.4271/2007-01-2038
  11. Hashimoto, K. “Inhibition Effect of Ethanol on Homogeneous Charge Compression Ignition of Heptane,” SAE Technical Paper 2008-01-2504 2008 10.4271/2008-01-2504
  12. Collin, R. Nygren, J. Richter, M. Aldén, M. et al. “Simultaneous OH- and Formaldehyde-LIF Measurements in an HCCI Engine,” SAE Technical Paper 2003-01-3218 2003 10.4271/2003-01-3218
  13. Jansons, M. Florea, R. Zha, K. Gingrich, E. “The Effect of HCHO Addition on Combustion in an Optically Accessible Diesel Engine Fueled with JP-8,” SAE Int. J. Fuels Lubr. 3 2 671 690 2010 10.4271/2010-01-2136
  14. Jansons, M. Zha, K. Florea, R. Taraza, D. et al. “Effect of Swirl Ratio and Wall Temperature on Pre-lnjection Chemiluminescence During Starting of an Optical Diesel Engine,” SAE Int. J. Engines 2 2 173 185 2010 10.4271/2009-01-2712
  15. Jansons, M. Florea, R. Estefanous, F. Taraza, D. Henein, N.A. Bryzik, W. “Chemiluminescence imaging of pre-injection reactions during engine starting” International Journal of Vehicle Design (IJVD) 2009 49 1/2/3 168 191
  16. Jansons, M. Florea, R. Zha, K. Estefanous, F. et al. “Optical and Numerical Investigation of Pre-Injection Reactions and Their Effect on the Starting of a Diesel Engine,” SAE Technical Paper 2009-01-0648 2009 10.4271/2009-01-0648
  17. Jansons, M. Florea, R. Zha, K. Florea, E. “The Combined Effect of HCHO and C2H4 Addition on Combustion in an Optically Accessible Diesel Engine Fueled with JP-8,” SAE Int. J. Engines 4 1 2048 2064 2011 10.4271/2011-01-1392
  18. Florea, R. Zha, K. Jansons, M. Taraza, D. Henein, N. “A CFD Study of the Effect of HCHO Addition on Autoignition and Combustion” Paper ASME Paper: ICEF2011-60212
  19. Idicheria, C. Pickett, L. “Formaldehyde Visualization Near Lift-off Location in a Diesel Jet,” SAE Technical Paper 2006-01-3434 2006 10.4271/2006-01-3434
  20. Donkerbroek, A.J. van Vliet, A.P. Somers, L.M.T. Frijters, P.J.M. Klein-Douwel, R.J.H. Dam, N.J. Meerts, W.L. ter Meulen, J.J. “Time- and space-resolved quantitative LIF measurements of formaldehyde in a heavy-duty diesel engine” Combustion and Flame 2010 157 1 155 166
  21. Curran, H.J. Gaffuri, P. Pitz, W.J. Westbrook, C.K. “A Comprehensive Modeling Study of n-Heptane Oxidation” Combustion and Flame 1998 114 1-2 149 177
  22. Marinov, N.M. “A detailed chemical kinetic model for high temperature ethanol oxidation” International Journal of Chemical Kinetics 1999 31 3 183 220
  23. Donkerbroek, A.J. van Vliet, A.P. Somers, L.M.T. Dam, N.J. ter Meulen, J.J. “Relation between hydroxyl and formaldehyde in a direct-injection heavy-duty diesel engine” Combustion and Flame 2011 158 3 564 572
  24. Kashdan, J. Docquier, N. Bruneaux, G. “Mixture Preparation and Combustion via LIEF and LIF of Combustion Radicals in a Direct-Injection, HCCI Diesel Engine,” SAE Technical Paper 2004-01-2945 2004 10.4271/2004-01-2945
  25. Gong, X. “The Effects of DTBP on the Oxidation of SI Primary Reference Fuels - A Study in an HCCI Engine and in a Pressurized Flow Reactor” 2005 Drexel University Philadelphia
  26. Seitzman, J.M. Haumann, J. Hanson, R.K. “Quantitative two-photon LIF imaging of carbon monoxide in combustion gases” Appl. Opt. 1987 26 14 2892 2899

Cited By

Recommended Content

Technical Paper Measurements of Gas Temperature in a HCCI Engine Using a Fourier Domain Mode Locking Laser
Technical Paper In-Situ Fuel Concentration Measurement Near Spark Plug by 3.392 μm Infrared Absorption Method-Application to a Port Injected Lean-Burn Engine
Journal Article Characterization of Internal Flow and Spray Behaviors of Hole-Type Nozzle under Tiny and Normal Injection Quantity Conditions for Diesel Engine