This content is not included in your SAE MOBILUS subscription, or you are not logged in.

An Empirical Study to Extend Engine Load in Diesel Low Temperature Combustion

Journal Article
ISSN: 1946-3936, e-ISSN: 1946-3944
Published August 30, 2011 by SAE International in United States
An Empirical Study to Extend Engine Load in Diesel Low Temperature Combustion
Citation: Asad, U., Han, X., and Zheng, M., "An Empirical Study to Extend Engine Load in Diesel Low Temperature Combustion," SAE Int. J. Engines 5(3):709-717, 2012,
Language: English


  1. Akagawa, H. Miyamoto, T. Harada, A. Sasaki, S. Shimazaki, N. Hashizume, T. Tsujimura, K. 1999 “Approaches to Solve Problems of the Premixed Lean Diesel Combustion” SAE Paper 1999-01-0183
  2. Akihama, K. Takatori, Y. Inagaki, K. Sasaki, S. Dean, A.M. 2001 “Mechanism of the Smokeless Rich Diesel Combustion by Reducing Temperature” SAE Paper 2001-01-0655
  3. Asad, U. Zheng, M. Han, X. Reader, G. et al. “Fuel Injection Strategies to Improve Emissions and Efficiency of High Compression Ratio Diesel Engines,” SAE Int. J. Engines 1 1 1220 1233 2009 10.4271/2008-01-2472
  4. Kitamura, T. Ito, T. “Mixing-Controlled, Low Temperature Diesel Combustion with Pressure Modulated Multiple-Injection for HSDI Diesel Engine,” SAE Int. J. Engines 3 1 461 478 2010 10.4271/2010-01-0609
  5. Li, T. Suzuki, M. Ogawa, H. 2009 “Characteristics of Smokeless Low Temperature Diesel Combustion in Various Fuel-Air Mixing and Expansion of Operating Load Range” SAE Paper 2009-01-1449
  6. Splitter, D. Hanson, R. Kokjohn, S. Reitz, R. 2011 “Reactivity Controlled Compression Ignition (RCCI) Heavy-Duty Engine Operation at Mid-and High-Loads with Conventional and Alternative Fuels” SAE Paper 2011-01-0363
  7. Asad, U. Zheng, M. 2010 “Evaluation of Diesel Low Temperature Combustion Fuel-Injection Strategies at Different Engine Loads” ASME Paper ICEF 2010-35172
  8. Kodama, Y. Nishizawa, I. Sugihara, T. Sato, N. Iijima, T. Yoshida, T. 2007 “Full-load HCCI Operation with Variable Valve Actuation System in a Heavy-Duty Diesel Engine” SAE Paper 2007-01-0215
  9. Ogawa, H. Miyamoto, N. Shimizu, H. Kido, S. 2006 “Characteristics of Diesel Combustion in Low Oxygen Mixtures with Ultra-high EGR” SAE Paper 2006-01-1147
  10. Alriksson, M. Rente, T. Denbratt, I. 2005 “Low Soot, Low NOx in a Heavy Duty Diesel Using High Levels of EGR” SAE Paper 2005-01-3836
  11. Heywood, J.B. Internal Combustion Engine Fundamentals McGraw-Hill New York 978-0071004992 1989
  12. Borman, G.L. Gagland, K.W. Combustion Engineering WCB/McGraw-Hill Boston 978-0070065673 1998
  13. Dronniou, N. Lejeune, M. Balloul, I. 2005 “Combination of High EGR Rates and Multiple Injection Strategies to Reduce Pollutant Emissions” SAE Paper 2005-01-3726
  14. Kimura, S. Aoki, O. Ogawa, H. Muranaka, S. Enomoto, Y. 1999 “New Combustion Concept for Ultra-Clean and High-Efficiency Small DI Diesel Engines” SAE Paper 1999-01-3681
  15. Kook, S. Bae, C. Miles, P.C. Choi, D. Pickett, L.M. 2005 “The Influence of Charge Dilution and Injection Timing on Low-Temperature Diesel Combustion and Emissions” SAE Paper 2005-01-3837
  16. Kimura, S. Ogawa, H. Matusi, M. Enomoto, Y. 2002 “An Experimental Analysis of Low Temperature and Premixed Combustion for Simultaneous Reduction of NOx and Particulate Emissions in Direct Injection Diesel Engines” Int J Engine Research 3 4 249 259
  17. Lewander, M. Johansson, B. Tunestal, P. Keeler, N. Tullis, S. Milovanovic, N. Bergstrand, P. 2009 “Evaluation of the Operating Range of Partially Premixed Combustion in a Multi Cylinder Heavy Duty Engine with Extensive EGR” SAE Paper 2009-01-1127
  18. Asad, U. Zheng, M. “Efficacy of EGR and Boost in Single-Injection Enabled Low Temperature Combustion,” SAE Int. J. Engines 2 1 1085 1097 2009 10.4271/2009-01-1126
  19. Asad, U. Zheng, M. “Efficiency & Stability Improvements of Diesel Low Temperature Combustion through Tightened Intake Oxygen Control,” SAE Int. J. Engines 3 1 788 800 2010 10.4271/2010-01-1118
  20. Ogawa, H. Li, T. Miyamoto, N. Kido, S. Shimizu, H. 2006 “Dependence of Ultra-High EGR and Low Temperature Diesel Combustion on Fuel Injection Conditions and Compression Ratio” SAE Paper 2006-01-3386
  21. Mendez, S. Thirouard, B. “Using Multiple Injection Strategies in Diesel Combustion: Potential to Improve Emissions, Noise and Fuel Economy Trade-Off in Low CR Engines,” SAE Int. J. Fuels Lubr. 1 1 662 674 2009 10.4271/2008-01-1329
  22. Li, T. Izumi, H. Shudo, T. Ogawa, H. Okabe, Y. 2007 “Improvements in Low Temperature Diesel Combustion with Blending ETBE to Diesel Fuel” SAE Paper 2007-01-1866

Cited By