This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
A New Method to Warm Up Lubricating Oil to Improve the Fuel Efficiency During Cold Start
Journal Article
2011-01-0318
ISSN: 1946-3936, e-ISSN: 1946-3944
Sector:
Topic:
Citation:
Will, F. and Boretti, A., "A New Method to Warm Up Lubricating Oil to Improve the Fuel Efficiency During Cold Start," SAE Int. J. Engines 4(1):175-187, 2011, https://doi.org/10.4271/2011-01-0318.
Language:
English
References
- van Basshuysen, R. Schaefer, F. “Internal Combustion Engine Handbook,” SAE International Warrendale, PA 978-0-7680-1139-5 2004 10.4271/R-345
- Maassen, F. J. Dohmen, J. Pischinger, S. Schwaderlapp, M. “Reibleistungsreduktion Konstruktive Maßnahmen zur Verbrauchseinsparung” MTZ 7 8 2005
- Pischinger, S. Kochanowski, H.-A. Steffens, C. Sonnen, S. Atzler, M. “Akustische Auslegung von Wälzlagern im Kurbeltrieb” MTZ 03 2009
- Bosch Automotive Handbook 7th Wiley 2007
- Tobergte, M. “Influence of Soak and Start Temperature on Fuel Economy and Emissions, A Chassis Roll Investigation” Ford 1999
- Will, F. “The importance of advanced test processes to reduce emissions and fuel consumption” ICSAT conference 2008
- Diehl, P. Haubner, F. Klopstein, S. Koch, F. “Exhaust Heat Recovery System for Modern Cars,” SAE Technical Paper 2001-01-1020 2001 10.4271/2001-01-1020
- Nakagawa, T Tsubouchi, M Suzuki, M. “Exhaust Heat Recirculation System for Actual Fuel Economy” Journal of the Society of Automotive Engineers of Japan 61 7 49 2007
- Woschni, G. “Die Berechnung der Wandwärmeverluste und der thermischen Belastung der Bauteile von Dieselmotoren” MTZ 31 1970 491 499
- Bargende, M. “Ein Gleichungsansatz zur Berechnung der instationären Wandwärmeverluste im Hochdruckteil von Ottomotoren” Dissertation TH Darmstadt 1990
- Hohenberg, G. “Experimented Erfassung der Wandwärme von Kolbenmotoren” Habilitation TU Graz 1980
- Annand, W. “Instantanious heat transfer rates to the cylinder head surface of a small compression-ignition engine” Proc Instn Mech Engrs 185 72 1971 976 987
- Kleinschmidt, W. Hebel, D. “Instationaere Waermeuebertragung in Verbrennungsmotoren - Theory, Simulation and comparison with Test Results” final report of research project K1600/1-2 German Research Association 1995
- Kleinschmidt, W. Hebel, D. “Instationaere Waermeuebertragung in Verbrennungsmotoren - Theory, Simulation and comparison with Test Results” VDI Progress Reports, No 383 Society of German Engineers (VDI) 1999
- Holman, J. P. “Heat Transfer” 10 th McGraw Hill New York 2010
- Boretti, A.A. Will, F. Watson, H.C. Brear, M.J. Dingli, R. Voice, G. “Comparison of static and dynamic engine models on the transient performance of a passenger vehicle powertrain” FISITA congress Munich, F2008-12-287
- Holzer, H. “Waermemanagement im Antriebsstrang von Verbrennungsmotoren” PhD Thesis Technical University of Vienna MTZ 5 2002
- Kunze, K. Wolff, S. Lade, I. Tonhauser, J. “A Systematic Analysis of CO2-Reduction by an Optimised Heat Supply during Vehicle Warm-Up,” SAE Technical Paper 2006-01-1450 2006 10.4271/2006-01-1450
- Farrant, P.E. Robertson, A. Hartland, J. Joyce, S. “The Application of Thermal Modelling to an Engine and Transmission to Improve Fuel Consumption Following a Cold Start,” SAE Technical Paper 2005-01-2038 2005 10.4271/2005-01-2038
- Gohl, M. “Schnelle Ölemissionsmessung bei Otto- und Dieselmotoren” FVV Vorhaben Nr. 758, Massenspektrometrische Bestimmung der Ölemission im Abgas von Otto- und Dieselmotoren FVV 2002
- Ebner, H. W. Jaschek, A. O. “Die Blow-by-Messung Anforderungen und Messprinzipien” MTZ Motortechnische Zeitschnft 59 1998 2 90 95
- Pischinger, S. “Verbrennungsmotoren Band II Vorlesungsumdruck” RWTH Aachen 1995
- van Basshuysen, R. Schaefer, F. “Modern Engine Technology from A to Z,” SAE International Warrendale, PA 978-0-7680-1705-2 2007 10.4271/R-373
- Schwarze, H. Brouwer, L. Knoll, G. Schlerege, F. Müller-Frank, U. Kopnarski, M. Emrich, S. “Ölalterung und Verschleiß im Ottomotor MTZ 2008 10
- “Owners manual Toyota Camry Hybrid” Toyota Motor Corporation 2006
- Will, F. “Process and device for lubrication of rotating and oscillating components” Patent application no. DE 102009013943.5 19 03 2009