This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Occupant Preferred Back Angle Relative to Head Restraint Regulations
Journal Article
2010-01-0779
ISSN: 1946-3995, e-ISSN: 1946-4002
Sector:
Topic:
Citation:
Kolich, M., "Occupant Preferred Back Angle Relative to Head Restraint Regulations," SAE Int. J. Passeng. Cars – Mech. Syst. 3(1):626-632, 2010, https://doi.org/10.4271/2010-01-0779.
Language:
English
References
- National Highway Traffic Safety Administration 2004 Laboratory test procedure for FMVSS 202aS - Head Restraints - Static Requirements December 22 2004 U.S. Department of Transportation
- SAE International Surface Vehicle Standard “Devices for Use in Defining and Measuring Vehicle Seating Accommodation,” SAE Standard J826 July 1995
- SAE International Surface Vehicle Recommended Practice “Driver Hand Control Reach,” SAE Standard J287 Feb. 2007
- SAE International Surface Vehicle Recommended Practice “Motor Vehicle Dimensions,” SAE Standard J1100 Sept. 2005
- SAE International Surface Vehicle Recommended Practice “Driver Selected Seat Position,” SAE Standard J1517 Dec. 1998
- Eriksson, L. 2005 Influence of head restraint position on long-term ais 1 neck injury risk International Journal of Crashworthiness 10 6 545 555
- Stemper, B. Yoganandan, N. Pintar, F. 2006 Effect of head restraint backset on head neck kinematics in whiplash Accident Analysis and Prevention 38 317 323
- Chapline, J. Ferguson, S. Lillis, R. Lund, A. Williams, A. 2000 Neck pain and head restraint position relative to the driver's head in rear-end collisions Accident Analysis and Prevention 32 287 297
- Reed, M. Flannagan, C. Manary, M. Schneider, L. 2001 Modeling vehicle occupant head and head restraint positions Technical Report UMTRI-2001-8
- Reed, M.P. Manary, M.A. Flannagan, C.A.C. Schneider, L.W. 2002 A statistical method for predicting automobile driving posture Human Factors 44 4 557 568
- Manary, M.A. Reed, M.P. Flannagan, C.A.C. Schneider, L.W. “ATD Positioning Based on Driver Posture and Position,” SAE Technical Paper 983163 1998