This content is not included in your SAE MOBILUS subscription, or you are not logged in.

1D Thermo-Fluid Dynamic Modeling of Reacting Flows inside Three-Way Catalytic Converters

Journal Article
2009-01-1510
ISSN: 1946-3936, e-ISSN: 1946-3944
Published April 20, 2009 by SAE International in United States
1D Thermo-Fluid Dynamic Modeling of Reacting Flows inside Three-Way Catalytic Converters
Sector:
Citation: Montenegro, G. and Onorati, A., "1D Thermo-Fluid Dynamic Modeling of Reacting Flows inside Three-Way Catalytic Converters," SAE Int. J. Engines 2(1):1444-1459, 2009, https://doi.org/10.4271/2009-01-1510.
Language: English

Abstract:

In this work a detailed model to simulate the transient behavior of catalytic converters is presented. The model is able to predict the unsteady and reacting flows in the exhaust ducts, by solving the system of conservation equations of mass, momentum, energy and transport of reacting chemical species. The en-gine and the intake system have not been included in the simulation, imposing the measured values of mass flow, gas temperature and chemical composition as a boundary condition at the inlet of the exhaust system. A detailed analysis of the diffusion stage triggering is proposed along with simplifications of the physics, finalized to the reduction of the calculation time. Submodels for water condensation and its following evaporation on the monolith surface have been taken into account as well as oxygen storage promoted by ceria oxides. Moreover, the interaction between the gas and the deposited water film has been modelled to simulate the effect of water dragging inside the monolith channel. The validation of the model has been carried out on the basis of ex-perimental measurements during hot and cold start at fixed engine operating conditions.