This content is not included in your SAE MOBILUS subscription, or you are not logged in.

Ring Pack Crevice Effects on the Hydrocarbon Emissions from an Air-Cooled Utility Engine

Journal Article
2008-32-0004
ISSN: 1946-3936, e-ISSN: 1946-3944
Published September 09, 2008 by SAE International in United States
Ring Pack Crevice Effects on the Hydrocarbon Emissions from an Air-Cooled Utility Engine
Sector:
Citation: Salazar, V. and Ghandhi, J., "Ring Pack Crevice Effects on the Hydrocarbon Emissions from an Air-Cooled Utility Engine," SAE Int. J. Engines 1(1):1319-1331, 2009, https://doi.org/10.4271/2008-32-0004.
Language: English

References

  1. Douglas, R. Glover, S. “The Feasibility of Meeting CARB/EPA 3 Emission Regulations for Small Engines,” SAE Paper 2007-32-0059
  2. US National Transportation Statistics 2006 US Department of Transportation Report
  3. EPA Nonroad Engine and Vehicle Emission Study-Report November 1991
  4. Salazar, V. M. Ghandhi, J.B. “Initial Estimation of the Piston Ring Pack Contribution the Hydrocarbon Emissions from a Small Engine,” SAE paper 2007-01-4014
  5. Cheng, W. K. Hamrin, D. Heywood, J. B. Hochgreb, S. Min, K. Norris, M. “An Overview of Hydrocarbon Emissions Mechanisms in Spark-Ignition Engines,” SAE Paper 932708 1993
  6. Heywood, J. B. “Internal Combustion Engine Fundamentals,” McGraw-Hill 1988
  7. Wentworth, J. T. “Piston and Ring Variable Affect Exhaust Hydrocarbon Emissions,” SAE Paper 680109 1968
  8. Alkidas, A. “Combustion Chamber Crevices: The Major Source of Engine-Out Hydrocarbon Emissions Under Fully Warmed Conditions,” Prog. In Energy and Comb. Sci. 25 253 273 1999
  9. Alkidas, A. C. Drews, R. J. Miller, W. F. “Effects of Piston Crevice Geometry on the Steady State Engine Out Hydrocarbon Emissions from an SI Engine,” SAE Paper 952537 1995
  10. Bignion, E. Spicher, U. “Investigation of the Influence of Top Land Crevice Geometry on Hydrocarbon Emissions from SI Engines,” SAE Paper 982560 1998
  11. Reitz, R. D. Kuo, T. “Modeling of HC Emissions Due to Crevice Flows in Premixed-Charge Engines,” SAE Paper 892085 1989
  12. Namazian, M. Heywood, J. B. “Flow in the Piston-Cylinder-Ring Crevices of a Spark-Ignition Engine: Effect on Hydrocarbon Emissions, Efficiency and Power,” SAE Paper 820088 1982
  13. Green, R. M. Cloutman, L. D. “Planar LIF Observations of Unburned Fuel Escaping the Upper Ring-Land Crevice in an SI Engine,” SAE Paper 970823 1997
  14. Lavoie G. A. Lorusso, J. A. Adamczyk, A. A. 1980 “Hydrocarbon Emissions Modeling for Spark Ignition Engines,” Combustion Modeling in Reciprocating Engines New York Plenum Press 1980 409 441
  15. Eng, J. A. “The Effect of Spark Retard on Engine-out Hydrocarbon Emissions,” SAE Paper 2005-01-3867 2005
  16. Eng, J. A. Leppard, W. R. Najt, P. M. Dryer, F. L. “Experimental Hydrocarbon Consumption Rate Correlations From a Spark Ignition Engine,” SAE Paper 972888 1997
  17. Prabhu, S. K. Bian, X. Miller, D. L. Cernansky, N. “Post Combustion Hydrocarbon Oxidation and Exhaust Emissions-Neat Fuel and Fuel Blend Studies,” SAE Paper 981456 1998
  18. Weiss, P. Keck, J. C. “Fast Sampling Valve Measurements of Hydrocarbons in the Cylinder of a CFR Engine,” SAE Paper 810149 1981
  19. Wu, K. C. Hochgreb, S. “Numerical Simulation of Post-Flame Oxidation of Hydrocarbons in Spark Ignition Engines,” SAE Paper 970886 1997
  20. Medina, S. C. Green, R. M. Smith, J. R. “Optical Measurements fo Hydrocarbons Emitted from a Simulated Crevice Volume in an Engine,” SAE Paper 840378 1984
  21. Salazar, V. M. Ghandhi, J. B. “Liquid Fuel Effects on the Unburned Hydrocarbon Emissions of a Small Engine,” SAE Paper 2006-32-003 2006
  22. Haugle, N. J. Ghandhi, J. B. “The Effects of Exhaust Gas Recirculation in Utility Engines,” SAE Paper 2006-32-0116 2006

Cited By