This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
The Influence of EGR on Auto-ignition Quality of Gasoline-like Fuels in HCCI Engines
Technical Paper
2004-01-2952
ISSN: 0148-7191, e-ISSN: 2688-3627
Annotation ability available
Sector:
Language:
English
Abstract
In previous studies it has been shown that the auto-ignition quality of a fuel at a given engine condition can be described by an octane index defined as, OI=(1-K) RON + K MON, where RON and MON characterize the fuel and the K-value depends only on the engine design and operating conditions. It has been shown that the K-value is highly dependent on the pressure and temperature history. Another important parameter is OI0, the OI of the fuel which gives heat release centred at top dead center; OI0 can be considered to be the requirement of the engine. In previous work, empirical relations for both K and OI0 in terms of in-cylinder pressure and temperature and engine speed and mixture strength were found but the influence of EGR was not considered. Therefore experiments have been done in a single cylinder engine, working in HCCI mode, at different operating conditions including various internal and external EGR rates, using fuels of different chemistries and different known RON and MON values.
Very high negative valve overlaps (NVO) produce high temperatures in the engine and fuel auto-ignition quality cannot be properly defined because different fuels release heat at roughly the same point in the engine cycle at a given operating condition. The same is found when the intake pressure is boosted to high levels. Away from these limits the previous empirical correlations for both K and OI0 hold good even in the presence of EGR. Thus the primary effect of NVO is the increase of temperature in the engine. Thus there is no evidence that there are additional effects of EGR on auto-ignition over and above those due to changes in the thermodynamic parameters caused by EGR.
Recommended Content
Authors
Citation
Risberg, P., Kalghatgi, G., and Ångstrom, H., "The Influence of EGR on Auto-ignition Quality of Gasoline-like Fuels in HCCI Engines," SAE Technical Paper 2004-01-2952, 2004, https://doi.org/10.4271/2004-01-2952.Also In
References
- Ryan, T.W. Matheaus, A. “Fuel requirements for HCCI engine operation” Thermo and Fluid Dynamic Processes in Diesel Engines 2002
- Montagne, X. Duret, P. “What will be the future combustion and fuel-related technology challenges?” “A new generation of engine combustion processes for the future?” Duret -P. Paris 2002 2-7108-0812-9 177
- Kalghatgi, G.T. “Fuel anti-knock quality - Part I, Engine Studies” SAE 2001-01-3584 2001
- Kalghatgi, G.T. “Fuel anti-knock - Part II. Vehicle studies- how relevant is Motor Octane Number (MON) for modern engines?” SAE 2001-01-3585 2001
- Kalghatgi, G.T. Risberg P Ångström H-E “A Method of Defining Ignition Quality of Fuels in HCCI Engines” SAE 2003-01-1816 (JSAE 20030120) 2003
- Risberg, P. Kalghatgi, G. Ångström H-E “Auto-ignition quality of gasoline-like fuels in HCCI engines” SAE 2003-01-3215
- Kalghatgi, G.T. Head, R.A. “The available and required auto-ignition quality of gasoline-like fuels in HCCI engines at high temperatures” SAE 2004-01-1969
- Koopmans, L. Stromberg, E. Denbratt, I. “The influence of PRF and commercial fuels with high octane number on the auto-ignition timing of an engine operated in HCCI combustion mode with negative valve overlap” SAE 2004-01-1967