Magazine Article

Punches and Dies for Rounding Corners of Metal Sheets

TBMG-7364

06/01/2001

Abstract
Content

Punch-and-die sets have been designed for use in rounding corners of rectangular metal sheets to specified radii. One of the traditional procedures for rounding a corner on a rectangular metal sheet is to first make a rough cut with a band saw and/or hand metal snips, then to file the roughly cut edge; this procedure is time-consuming and does not result in an accurate radius. The use of a punch-and-die set of the present type takes less time and results in a corner with an accurate radius.

Meta TagsDetails
Citation
"Punches and Dies for Rounding Corners of Metal Sheets," Mobility Engineering, June 1, 2001.
Additional Details
Publisher
Published
Jun 1, 2001
Product Code
TBMG-7364
Content Type
Magazine Article
Language
English