Gradient and Mass Estimation from CAN Based Data for a Light Passenger Car

Event
SAE 2015 World Congress & Exhibition
Authors Abstract
Content
We present a method for the estimation of vehicle mass and road gradient for a light passenger vehicle. The estimation method uses information normally available on the vehicle CAN bus without the addition of extra sensors. A composite parameter estimation algorithm incorporating a nonlinear adaptive observer structure uses vehicle speed over ground and driving torque to estimate mass and road gradient. A system of filters is used to avoid deriving acceleration directly from wheel speed. In addition, a novel data fusion method makes use of the regressor structure to introduce information from other sensors in the vehicle. The dynamics of the additional sensors must be able to be parameterised using the same parameterisation as the complete vehicle system dynamics. In this case we make use of an Inertial Measurement Unit (IMU) which is part of the vehicle safety and Advanced Driver Assist Systems (ADAS). Therefore, a method using some filtering and supervisory logic is employed to give a sensible update behaviour for the vehicle mass estimation algorithm. The main function of the supervisor is to reject the mass estimate produced by unsuitable available data due to unmodelled loss forces. Good estimation results are obtained from data from a vehicle which was also fitted with some additional instrumentation including GPS sensors and a high quality IMU for scientific verification purposes.
Meta TagsDetails
DOI
https://doi.org/10.4271/2015-01-0201
Pages
9
Citation
Wragge-Morley, R., Herrmann, G., Barber, P., and Burgess, S., "Gradient and Mass Estimation from CAN Based Data for a Light Passenger Car," Passenger Cars - Electronic and Electrical Systems 8(1):137-145, 2015, https://doi.org/10.4271/2015-01-0201.
Additional Details
Publisher
Published
Apr 14, 2015
Product Code
2015-01-0201
Content Type
Journal Article
Language
English