The Effect of Surface Finish on Aluminum Sheet Friction Behavior

Event
SAE 2011 World Congress & Exhibition
Authors Abstract
Content
Aluminum sheet is commercially available in three surface finishes, mill finish (MF), electric discharge texture (EDT), and dull finish (DF). This surface finish impacts the friction behavior during sheet metal forming. A study was done to compare ten commercially available sheet samples from several suppliers. The friction behavior was characterized in the longitudinal and transverse directions using a Draw Bead Simulator (DBS) test, resulting in a coefficient of friction (COF) value for each material. Characterization of the friction behavior in each direction provides useful data for formability analysis. To quantitatively characterize the surface finish, three-dimensional MicroTexture measurements were done with a WYKO NT8000 instrument. In general, the MF samples have the smoothest surface, with Sa values of 0.20-0.30 μm and the lowest COF values. The EDT samples have the roughest surface, with Sa values of 0.60-1.00 μm, and the highest COF values. The DF sample falls between the MF and EDT with Sa = 0.60 μm. Also, the EDT and DF samples have a more isotropic surface, as indicated by Stylus X Ra/Stylus Y Ra = 0.97-1.01, and the COF values are approximately the same in the transverse and longitudinal directions for these samples. The MF samples are less isotropic, with Stylus X Ra/Stylus Y Ra = 1.79-4.87, and the COF values are lower in the transverse direction than in the longitudinal direction for the MF samples.
Meta TagsDetails
DOI
https://doi.org/10.4271/2011-01-0534
Pages
8
Citation
Cohen, D., sanchez PhD, L., Hartfield-Wunsch, S., and Brattstrom, L., "The Effect of Surface Finish on Aluminum Sheet Friction Behavior," SAE Int. J. Mater. Manuf. 4(1):818-825, 2011, https://doi.org/10.4271/2011-01-0534.
Additional Details
Publisher
Published
Apr 12, 2011
Product Code
2011-01-0534
Content Type
Journal Article
Language
English