Analysis of Trimming Processes for Advanced High Strength Steels

Event
SAE World Congress & Exhibition
Authors Abstract
Content
Current die design recommendations attempt to limit the production of burrs through accurate alignment of the upper and lower edges. For common automotive exterior sheet, this translates to a gap less than 0.06mm. Unfortunately, the tolerances required by such standards often exceed the capabilities of many trim dies. The objective of the research described in this paper is to study the mechanisms of burrs generation and their impact on AHSS formability in stretch flanging. Experimental results on influence of trimming conditions on the shape of the sheared surface will be combined with the results of stretching strips after trimming.
Meta TagsDetails
DOI
https://doi.org/10.4271/2008-01-1446
Pages
6
Citation
Golovashchenko, S., and Ilinich, A., "Analysis of Trimming Processes for Advanced High Strength Steels," SAE Int. J. Mater. Manf. 1(1):818-823, 2009, https://doi.org/10.4271/2008-01-1446.
Additional Details
Publisher
Published
Apr 14, 2008
Product Code
2008-01-1446
Content Type
Journal Article
Language
English