This content is not included in your SAE MOBILUS subscription, or you are not logged in.
BOLTS, SCREWS AND NUTS - EXTERNAL WRENCHING, METRIC THREADS - DESIGN PARAMETERS FOR
- Aerospace Standard
Published December 01, 1986 by SAE International in United States
To fully define the following requirements for bolts with spline and hexagon heads of strength class up to but not including 1250 MPa:
Head dimensions (See 3.1).
Shank dimensions (See 3.2).
Geometric control (See 3.3).
Surface texture (See 3.4).
This standard is based on one class of thread after all processing, including coating or plating, has been completed as follows: Tolerance class 4h6h.
For particulars of thread, see AS 1370. For thread runout and lead threads, see AS 3062.
Data Sets - Support Documents
No Datasets Available
E-25 General Standards for Aerospace and Propulsion Systems
The SAE E-25 General Standards for Aerospace & Propulsion Systems committee addresses aerospace propulsion systems and components. These systems and components include bolts, screws, nuts, washers, studs, rivets, pins, covers, O-rings, brackets, plugs and associated procurement requirements, as well as solid film lubricants and design specifications for screw threads and fastener assembly requirements.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.