This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Test Methods and Equipment for Lighting Devices for Use on Vehicles Less than 2032 mm in Overall Width
- Ground Vehicle Standard
- J575_201508
- Revised
Downloadable datasets available
Annotation ability available
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice is intended as a guide toward standard practice and is subject to change to keep pace with experience and technical advances. This document provides standardized laboratory tests, test methods and equipment, and requirements for lighting devices covered by SAE Recommended Practices and Standards. It is intended for devices used on vehicles less than 2032 mm in width. Tests for vehicles larger than 2032 mm in overall width are covered in SAE J2139. Device specific tests and requirements can be found in applicable SAE technical reports.
Rationale
Underhood Thermal Test added for lamp assemblies with housings exposed to engine compartments. The Underhood Thermal Test is used to ensure lamp assemblies are capable of operating without degradation in conditions of elevated temperatures generated by operation combined with heat input from the surrounding vehicle environment, including engine compartment components. See new sections 4.9 and 5.9. A new figure 5 was added in section 4.9 resulting in re-numbering of two figures and subsequent references in the text. Table of contents updated to reflect additions and omitted 4.1 heading added.
Recommended Content
Ground Vehicle Standard | Test Methods and Equipment for Lighting Devices for Use on Vehicles Less than 2032 mm in Overall Width |
Ground Vehicle Standard | Passenger Car Windshield Washer Systems |
Ground Vehicle Standard | Headlamp Cleaners |
Topic
Data Sets - Support Documents
Title | Description | Download |
---|---|---|
[Unnamed Dataset 1] | ||
[Unnamed Dataset 2] | ||
[Unnamed Dataset 3] | ||
Table 1 | Cycle times (minutes) | |
Table 2 | Temperature classification for housing side of lamp |
Issuing Committee
Test Methods and Equipment Stds Committee
The Test Methods and Equipment Standards Committee is part of the Lighting Systems Steering Committee that reports to the Motor Vehicle Council (MVC).
Reference
Number | Title |
---|---|
ASTMB117 | This document is not part of the subscrption. |
ASTMC150 | This document is not part of the subscrption. |
ASTMD471 | This document is not part of the subscrption. |
ASTME308 | This document is not part of the subscrption. |
DIN75-220 | This document is not part of the subscrption. |
ISO 12103-1 | This document is not part of the subscrption. |
J1330_201409 | Photometry Laboratory Accuracy Guidelines |
J1889_201907 | LED Signal and Marking Lighting Devices |
J2139_201412 | Tests for Signal and Marking Devices Used on Vehicles 2032 mm or More in Overall Width |
J2560_201909 | Halogen Light Source Performance Requirements for Motor Vehicle Forward Lighting |
J2650_201305 | Performance Requirements for Light Emitting Diode (LED) Road Illumination Devices |
J387_201404 | Terminology - Motor Vehicle Lighting |
J573G_197612 | Miniature Lamp Bulbs |
J577_201509 | Vibration Test Machine and Operation Procedure |
MIL-STD-810 | This document is not part of the subscrption. |
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.