This content is not included in your SAE MOBILUS subscription, or you are not logged in.
AUTOMOTIVE TUBE FITTINGS
- Ground Vehicle Standard
Published June 01, 1992 by SAE International in United States
This SAE Standard covers complete general and dimensional specifications for the various types of tube fittings intended for general application in the automotive, appliance, and allied fields. See SAE J1131 for the performance requirements of reuseable (push to connect) fittings intended for use in automotive air brake systems.
Flare type fittings shall be as specified in Figures 1 to 4 and Tables 3 to 5.
Inverted flared type fittings shall be as specified in Figures 5 to 11 and Tables 3, 6, 7, 8, and 9. Gages and gaging procedures pertaining to inverted flared tube fittings are given in Appendix A.
Tapered sleeve compression type fittings intended for general use with annealed copper alloy tubings shall be as specified in Figures 12 to 17, and Tables 3, 10, 11, and 12. To assure satisfactory performance, spherical sleeve compression type fitting components (see SAE J246) should not be intermixed with tapered sleeve compression type fitting components when assembling connections in areas where both types are available.
Dimensions of single and double 45 degree flares on tubing to be used in conjunction with flared and inverted flared fittings are given in Figure 2 and Table 3 of SAE J533.
The following general specifications supplement the dimensional data for all types of fittings contained in Tables 3 to 13 with respect to all unspecified detail.
Data Sets - Support Documents
No Datasets Available
Air Brake Tubing and Tube Ftg Committee
The Air Brake Tubing and Tube Fittings Committee develops and maintains SAE Standards, Recommended Practices and Information Reports relating to tubing and fittings of air brake systems. Participants in the Air Brake Tubing and Tube Fittings Committee of the Truck and Bus Brake and Advanced Driver Assistance Systems Steering Committee includes OEMs, suppliers, consulting firms, government and other interested parties.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.