This content is not included in
your SAE MOBILUS subscription, or you are not logged in.
Modal Testing and Identification of Lower Order Tire Natural Frequencies of Radial Tires
- Ground Vehicle Standard
- J2710_200510
- Issued
Sector:
Issuing Committee:
Language:
English
Scope
This SAE Recommended Practice describes test methods for measuring and identifying the natural frequencies for the lower order modes of an inflated radial tire with a fixed spindle while expending modest effort and employing a minimum of test equipment. The methods apply to any size of radial tire so long as the test equipment is properly scaled to conduct the measurements for the intended test tire. Two types of boundary conditions are considered for the tire: unloaded and loaded against a flat surface. The test involves the performance and measurement of an input vibratory force (excitation) to the tire and the corresponding vibratory output (response). The data are suitable for use in determining parameters for road load models and for comparative evaluations of the measured properties in research and development.
Rationale
This document was developed as part of a set of Recommended Practices intended to allow modelers to determine the parameters required by any of the common tire models for calculating spindle loads given the road surface profile from a single set of experimental results, thus, eliminating duplicate testing.
Recommended Content
Data Sets - Support Documents
No Datasets Available
Issuing Committee
Vehicle Dynamics Standards Committee
The Vehicle Dynamics Standards Committee (VDSC) reports to the Vehicle Performance Steering Committee. The VDSC develops Information Reports, Recommended Practices and Standards related to the dynamics of passenger cars and light trucks, excluding trailers. The committee establishes tests and analyses that contribute to the understanding of the ride and handling performance of the total vehicle as a dynamic system.
Reference
| Number | Title |
|---|---|
| ISO17025 | This document is not part of the subscrption. |
| J2047_201303 | Tire Performance Terminology |
| J2047_201911 | Tire Performance Terminology |
| J2429_201509 | Free-Rolling Cornering Test for Truck and Bus Tires |
| OSHA1910.177 | This document is not part of the subscrption. |
* Redlines comparisons are available for those standards
listed in the Revision History that contain a radio button. A
redline comparison of the current version against a revision is
accomplished by selecting the radio button next to the standard and
then selecting 'compare'. At this time, Redline versions only exist
for some AMS standards. SAE will continue to add redline versioning
with ongoing updates to SAE MOBILUS.