This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Bleed-Air Pneumatic Systems for Gas Turbine Equipped Marine and Amphibious Craft
- Ground Vehicle Standard
Published May 12, 2015 by SAE International in United States
Downloadable datasets availableAnnotation ability available
This Information Report provides a description of bleed-air pneumatic system elements and identifies parameters required to define the requirements for a detailed specification. Specific design requirements are dependent on the application and should be incorporated in a detailed specification.
Revised to complete document conversion from (Aerospace) Hydrospace Information Report HIR 1559 to Surface Vehicle Information Report SAE J1775; References were updated, Section 2.2 was added for related (but not directly cited) references, Section 3.1 was updated to add reliability improvements using PLC controlled air valves. Section 3.4.1 was updated to add reference to SAE J1781 to replace listing of nitrogen strengthened and precipitation hardened alloys, and to suggest consideration of heat pipe (tube) materials to reduce scaling in salt water cooling. Section 3.5 was updated to add reference MIL-STD-1472 for guidelines for maximum effective environmental temperature in manned spaces.
Data Sets - Support Documents
|Unnamed Dataset 1|
|Unnamed Dataset 2|
|Unnamed Dataset 3|
|Unnamed Dataset 4|
|ARP1796||Engine Bleed Air Systems for Aircraft|
|ARP699||This document is not part of the subscrption.|
|ARP735||AEROSPACE VEHICLE CRYOGENIC DUCT SYSTEMS|
|J1781||This document is not part of the subscrption.|
|MIL-C-19713||This document is not part of the subscrption.|
|MIL-S-901||This document is not part of the subscrption.|
|MIL-STD-1471||This document is not part of the subscrption.|
|MIL-STD-167-1||This document is not part of the subscrption.|
|MIL-STD-740-2||This document is not part of the subscrption.|
|MIL-STD-777||This document is not part of the subscrption.|
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.