This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Selecting and Specifying Hot and Cold Rolled Steel Sheet and Strip
- Ground Vehicle Standard
Published June 01, 1986 by SAE International in United States
This SAE Recommended Practice outlines a procedure for selecting the proper specification for carbon steel sheet and strip which are purchased to make an identified part. It also describes how codes or symbols for specifying certain characteristics may be used in electronic data processing systems. Characteristics covered are: (A) Hot or cold rolled. (B) Sheet or strip. (C) Severity of draw (quality of steel). (D) Surface condition (finish, etc.). (E) Edge condition. (F) Dimensions. It is intended that other characteristics and part identification be covered by a supplement to the specification, as necessary.
|Special Publication||Stainless Steel - The New Light-Weight Option|
|Magazine Issue||Automotive Engineering International 2013-09-17|
|Journal Article||Applicability of Micromechanics Model Based on Actual Microstructure for Failure Prediction of DP Steels|
Data Sets - Support Documents
No Datasets Available
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.