This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Rollover Protective Structures (ROPS) for Wheeled Agricultural Tractors
- Ground Vehicle Standard
Published May 01, 1989 by SAE International in United States
Fulfillment of the intended purpose requires testing as follows: A laboratory test, under repeatable and controlled loading, to permit analysis of the ROPS for compliance with the performance requirements of this SAE Standard. Either the static test (6.1) or the dynamic test (6.2) shall be conducted. A crush test to verify the effectiveness of the deformed ROPS in supporting the tractor in an upset attitude. A field upset test under reasonably controlled conditions, both to the rear and side, to verify the effectiveness of the protective system under actual dynamic conditions. (See 184.108.40.206 for requirements for the omission of this test). In addition to the laboratory and field loading requirements, there is a temperature-material requirement. (See 7.1.2.) The test procedures and performance requirements outlined in this document are based on currently available engineering data.
Data Sets - Support Documents
No Datasets Available
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.