This content is not included in your SAE MOBILUS subscription, or you are not logged in.
Nuts, Self-Locking, Steel, Corrosion and Heat Resistant High Strength, All Metal 1200 °F Use, UN Thread Form
- Aerospace Standard
Published December 19, 2008 by SAE International in United States
This document covers all metal, self-locking wrenching nuts, plate nuts, shank nuts, and gang channel nuts made from a corrosion and heat resistant steel of the type identified under the Unified Numbering System as UNS S66286 and of 160 ksi tensile strength at room temperature, with maximum test temperature of parts at 1200 °F.
TO CORRECT FIGURES 3 AND 4 FOR PERMANENT SET PITCH DIAMETERS APPLICABLE TO THE .003 INCH REDUCTION REQUIRED PER SECTION 3.8 AND GENERAL SAE FORMATING REQUIREMENTS.
Data Sets - Support Documents
No Datasets Available
E-25 General Standards for Aerospace and Propulsion Systems
The SAE E-25 General Standards for Aerospace & Propulsion Systems committee addresses aerospace propulsion systems and components. These systems and components include bolts, screws, nuts, washers, studs, rivets, pins, covers, O-rings, brackets, plugs and associated procurement requirements, as well as solid film lubricants and design specifications for screw threads and fastener assembly requirements.
* Redlines comparisons are available for those standards listed in the Revision History that contain a radio button. A redline comparison of the current version against a revision is accomplished by selecting the radio button next to the standard and then selecting 'compare'. At this time, Redline versions only exist for some AMS standards. SAE will continue to add redline versioning with ongoing updates to SAE MOBILUS.